Danfoss RET1000 MD User Manual - Page 5

Browse online or download pdf User Manual for Thermostat Danfoss RET1000 MD. Danfoss RET1000 MD 8 pages. Electronic dial setting room thermostat, delayed start

Print Page

The heating system will not work if a timeswitch or programmer has

switched it off.

The way to set and use your room thermostat is to find the lowest

temperature setting that you are comfortable with, and then leave it

alone to do its job. The best way to do this is to set the room thermostat

to a low temperature – say 18°C – and then turn it up by one degree

each day until you are comfortable with the temperature. You won't

have to adjust the thermostat further. Any adjustment above this

setting will waste energy and cost you more money.

If your heating system is a boiler with radiators, there will usually

be only one room thermostat to control the whole house. But you

can have different temperatures in individual rooms by installing

thermostatic radiator valves (TRVs) on individual radiators. If you don't

have TRVs, you should choose a temperature that is reasonable for the

whole house. If you do have TRVs, you can choose a slightly higher

setting to make sure that even the coldest room is comfortable, then

prevent any overheating in other rooms by adjusting the TRVs.

Room thermostats need a free flow of air to sense the temperature,

so they must not be covered by curtains or blocked by furniture.

Nearby electric fires, televisions, wall or table lamps may prevent the

thermostat from working properly.

Danfoss Heating