3T-Components 3T-MOTORS 3T35-13B Installation & Operating Instructions Manual - Page 11
Browse online or download pdf Installation & Operating Instructions Manual for Indoor Furnishing 3T-Components 3T-MOTORS 3T35-13B. 3T-Components 3T-MOTORS 3T35-13B 20 pages. Shutter / awning motors
Print Page
INSTALLATION INSTRUCTIONS
Setting the end positions:
8
Setting the end points with set button
Connect tubular motor to switch or timer
Test the direction of rotation of the motor and change it if necessary.
To change the direction of rotation, swap the up and down leads
•
(brown and black cable) on the switch/timer.
Setting lower end point
Do not fasten roller shutter armor
•
Set the switch/timer to „DOWN"
•
Run tubular motor in downward direction and define end point by pressing
•
set the set button (motor stops)
If the shaft has to be turned a little to hook in the suspension springs,
•
press the set button. This causes the motor to turn the shaft step by step.
8.1
8.2
8.4
8.5
Setting upper end point
Hang the roller shutter curtain with suspension springs on the roller
•
shutter shaft
>
Abb. 8.4
Set the switch/timer to „UP"
>
•
Run the motor with the roller shutter in the upward direction. When the
•
end point is reached, stop the motor by pressing the set button.
If the motor stops before the upper end point, a readjustment is possible
•
by pressing the set button (switch/timer must be set to „UP").
Continuous pressing = motor continues to move upwards.
Pressing once = motor continues to move upwards step by step.
>
fig. 8.1
>
fig. 8.2
>
fig. 8.3
8.3
8.6
Abb. 8.5
>
Abb. 8.6
Setting the end points with adjustment cable ESK
Connect tubular motor to ESK
Up button
Set button
Down button
Test the direction of rotation of the motor and change it if necessary.
To change the direction of rotation, swap the up and down leads (brown and
•
black cable) on the adjustment cable
Setting lower end point
Do not fasten roller shutter armor
•
Set the switch of the adjustment cable to „DOWN"
•
Run tubular motor in downward direction and define end point by pressing
•
the green set button (motor stops)
If the shaft has to be turned a little to hook in the suspension springs,
•
press the set button. This causes the motor to turn the shaft step by step.
8.7
8.8
8.10
8.11
Setting upper end point
Hang the roller shutter curtain with suspension springs on the roller
•
shutter shaft
>
Abb. 8.10
Set the adjustment cable to „UP"
•
Run the motor with the roller shutter in the upward direction. When the
•
end point is reached, stop the motor by pressing the green set button.
If the motor stops before the upper end point, a readjustment is possible
•
by pressing the set button (ESK must be set to „UP").
Continuous pressing = motor continues to move upwards.
Pressing once = motor continues to move upwards step by step.
>
fig. 8.7
>
fig. 8.8
>
fig. 8.9
8.9
8.12
>
Abb. 8.11
3T-MOTORS Tubular motors | Installation instructions
>
Abb. 8.12
11