Danfoss VLT AutomationDrive FC 302 Installation Instructions Manual - Page 6

Browse online or download pdf Installation Instructions Manual for Control Unit Danfoss VLT AutomationDrive FC 302. Danfoss VLT AutomationDrive FC 302 6 pages. Igbt module replacement for d1h–d8h drives
Also for Danfoss VLT AutomationDrive FC 302: Operating Manual (16 pages), Installation Manual (20 pages), Installation Instructions (4 pages), Installation Instructions Manual (12 pages), Installation Manual (18 pages), Installation Instructions Manual (8 pages), Installation Instructions Manual (10 pages), Installation Manual (6 pages), Installation Manual (16 pages), Operating Instructions Manual (16 pages), Installation Instructions Manual (6 pages), Installation Manual (16 pages), Installation Manual (8 pages), Installation Instructions Manual (6 pages), Installation Manual (6 pages)

Print Page

Danfoss VLT AutomationDrive FC 302 Installation Instructions Manual

Unscrew the 2 T10 screws holding the control card

EMC shield (4 screws if MCO is installed).

If MCO is installed, remove the MCO ribbon

cable.

Remove the control card EMC shield.

T10 screws

EMC shield

Illustration 1.7 Screws and EMC Shield

Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products already on

order provided that such alterations can be made without subsequential changes being necessary in specifications already agreed. All trademarks in this material are property of the respective companies. Danfoss

Danfoss A/S

Ulsnaes 1

DK-6300 Graasten

vlt-drives.danfoss.com

130R0788

Re-assemble the new control card in reverse order.

MI93A102

*MI93A102*

10.

Unscrew the 3 T10 screws and remove them.

11.

Gently remove the control card from the upper-right

socket. Avoid overbending and contact with

electronic components.

Control card

T10 screws

Illustration 1.8 Control Card and T10 Screws

03/2017