Danfoss VLT AutomationDrive FC 302 Installation Manual - Page 9

Browse online or download pdf Installation Manual for Control Unit Danfoss VLT AutomationDrive FC 302. Danfoss VLT AutomationDrive FC 302 16 pages. Igbt module replacement for d1h–d8h drives
Also for Danfoss VLT AutomationDrive FC 302: Operating Manual (16 pages), Installation Manual (20 pages), Installation Instructions (4 pages), Installation Instructions Manual (6 pages), Installation Instructions Manual (12 pages), Installation Manual (18 pages), Installation Instructions Manual (8 pages), Installation Instructions Manual (10 pages), Installation Manual (6 pages), Operating Instructions Manual (16 pages), Installation Instructions Manual (6 pages), Installation Manual (16 pages), Installation Manual (8 pages), Installation Instructions Manual (6 pages), Installation Manual (6 pages)

Print Page

Installation

3.5 Mounting

Check whether the fieldbus option is already

mounted in the frequency converter. If already

mounted, go to step 6. If not mounted, go to

step 2.

Remove the LCP or blind cover from the

frequency converter.

Use a screwdriver to remove the front cover and

the LCP cradle.

Mount the fieldbus option. Mount the option

with the connector facing up for top cable entry

(see Illustration 3.3), or with the connector facing

down for bottom cable entry (see Illustration 3.4).

If an MCB option is installed, only top cable entry

is possible.

Remove the knock-out plate from the new LCP

cradle.

Mount the new LCP cradle.

LCP

LCP cradle

Fieldbus option

Connector

Illustration 3.2 Exploded View

MG33J402

Installation Guide

Illustration 3.3 Top Cable Entry: Option Mounted with

Connector Facing Up

Illustration 3.4 Bottom Cable Entry: Option Mounted with

Connector Facing Down