Danfoss vlt soft starter mcd 500 Installation Instructions Manual - Page 5
Browse online or download pdf Installation Instructions Manual for Control Unit Danfoss vlt soft starter mcd 500. Danfoss vlt soft starter mcd 500 17 pages. Usb module
Also for Danfoss vlt soft starter mcd 500: Installation Instructions Manual (6 pages), Installation Instructions (5 pages)
Print Page
MCD Modbus Module Instructions
1
For MCD 500 models MCD5-0068B and smaller this value will be 10 times greater than the value
displayed on the LCP.
2
See the relevant soft starter literature for a complete parameter list. The first product parameter
is always allocated to register 40009. The last product parameter is allocated to register 40XXX,
where XXX = 008 plus total number of available parameters in the product.
N.B.!:
The numbering of parameter options via serial communications differs slightly from the
numbering displayed on the LCP. Numbering via the Modbus Module starts at 0, so for
Par. 2-1 Phase Sequence, the options are 1~3 on the LCP but 0~2 via the module.
MG.17.F5.02 - VLT® is a registered Danfoss trademark
Modbus Register
5