Danfoss iC7 Series Installation Manual - Page 5

Browse online or download pdf Installation Manual for Media Converter Danfoss iC7 Series. Danfoss iC7 Series 10 pages. In-bottom/out-back cooling kit for fa09-fa10, frequency converters
Also for Danfoss iC7 Series: Installation Manual (8 pages), Installation Manual (8 pages), Installation Manual (6 pages), Installation Manual (14 pages), Installation Manual (16 pages), Installation Manual (8 pages), Installation Manual (8 pages), Installation Manual (16 pages), Installation Manual (16 pages), Installation Manual (6 pages), Installation Manual (6 pages), Installation Manual (16 pages), Installation Manual (18 pages)

Print Page

In-back/Out-back Cooling Kit for FK11/FB11 and FK12/FB12

Installation Guide

2.4 Installing the Bottom Cover (Pedestal Attached)

The bottom cover can be installed either before or after the pedestal is attached to the cabinet. To install the bottom cover plate

with the pedestal attached, use the following steps. See

If the pedestal is not attached, see

Procedure

Remove paper backing from the bottom gasket.

Adhere the bottom gasket to the upper side of the bottom cover.

Remove the front panel of the pedestal by removing 4 M5x12 screws.

Retain the screws.

Inside the pedestal, position the bottom cover and gasket over the opening at the lower end of the cooling channel.

Secure the bottom cover using the M5x14 screws (T25) included with the kit.

Torque screws to 2.3 Nm (20 in-lb). Installation in FK11/FB11 frequency converters requires 8 screws; installation in FK12/

FB12 frequency converters requires 10 screws.

Install the pedestal front panel and secure with 4 M5x12 screws previously removed in step 3.

Illustration 3: Bottom View of Cabinet and Pedestal

Cabinet

M5x12 screw

Front panel of pedestal

Illustration

2.5 Installing the Bottom Cover (Before

Pedestal).

Pedestal

M5x14 screw

Bottom cover plate

AN361429087579en-000101 / 136R0289 | 5

Installation