Danfoss VLT HVAC Drive FC 102 Installation Manual - Page 14

Browse online or download pdf Installation Manual for Media Converter Danfoss VLT HVAC Drive FC 102. Danfoss VLT HVAC Drive FC 102 18 pages. Igbt module replacement for d1h–d8h drives
Also for Danfoss VLT HVAC Drive FC 102: Operating Manual (16 pages), Installation Manual (20 pages), Installation Instructions Manual (6 pages), Installation Instructions Manual (12 pages), Installation Instructions Manual (11 pages), Installation Instructions Manual (8 pages), Installation Instructions Manual (10 pages), Installation Manual (6 pages), Operating Instructions Manual (16 pages), Installation Instructions Manual (6 pages), Installation Manual (16 pages), Installation Manual (8 pages), Instruction Manual (16 pages), Installation Instructions Manual (6 pages), Installation Manual (6 pages)

Print Page
Danfoss VLT HVAC Drive FC 102 Installation Manual
Installation
Wiring procedure for enclosure types D, E, and F
1.
Mount the pre-configured cable wires with the
connectors on the fieldbus option. For cable
specifications, refer to chapter 3.8.2 Cable Specifi-
cations.
3
3
2.
Fix the cable to the metal base plate using the
springs, see Illustration 3.12.
3.
Tie down the cable and route it with other
control wires inside the unit, see Illustration 3.12.
Illustration 3.12 Wiring for Enclosure Types D, E, and F
NOTICE
Do not strip the Ethernet cable. Do not ground it via the
strain relief plate. Ground the screened Ethernet cables
through the RJ 45 connector on the PROFINET interface.
12
Installation Guide

3.9 Reassembling Cover

3.10 Applying Power

Follow the instructions in the frequency converter
Operating Instructions to commission the frequency
converter. The frequency converter automatically detects
the PROFINET interface and 2 new parameter groups
(group 9 and group 12) appear.

3.11 Checking Network Cabling

NOTICE
After installing the PROFINET interface, be aware of the
following parameter settings:
8-01 Control Site: [2] Control word only or [0] Digital and
control word
8-02 Control Word Source: [3] Option A
Danfoss A/S © Rev. 07/2014 All rights reserved.
1.
Mount the new front cover and the LCP.
2.
Attach the sticker with the correct product name
to the front cover.
MG90U402