Dunster House PS604 Installation Manual - Page 3

Browse online or download pdf Installation Manual for Play Sets & Playground Equipment Dunster House PS604. Dunster House PS604 10 pages. Monkey bars

Print Page

Please use this page to ensure that the fixings for your play system are installed

correctly. You must use these claw washers in every location where you are

instructed to use an M10 (10mm diameter) bolt. These pronged washers create a

sleeve for the square 'neck' of the bolt to fit into.

You must always use a nyloc nut wherever you are instructed to use an M10 nut.

Follow the steps below to install the configuration:

1. Place the claw washer onto the coach bolt. Ensure that the square hole of the washer passes

over the 'neck' of the bolt and insert it into the pre-drilled holes in the pieces of timber that

you wish to join together, passing it all the way through.

2. Using a hammer, firmly but gently tap the domed head of the bolt, knocking the claw washer

into the timber.

3. Place the rest of the components onto the bolt except for the green cap top.

4. Hold the bolt head against the timber with your hand whilst tightening the self-locking M10

(nyloc) nut with a 17mm spanner.

a. As you tighten the nut, the claw washer gets pulled into the timber.

b. Do not over tighten the nut.

5. Push the cover onto the safety cap.

6. Regularly check the tightness of all of the screws and bolts on your climbing frame to ensure

that the structure remains rigid.

7. Continue to follow all of the warnings and maintenance instructions in your Installation

Manual for your specific climbing frame.

Claw Washer

Square

Shoulder

Coach

Bolt

Bolt Configuration

Green

20mm

Cap

Washer

(base)

Green

M10

Cap

(Nyloc)

(top)

Nut

Claw Washer