DUO-FAST DFCR175C Operating Manual - Page 8

Browse online or download pdf Operating Manual for Power Tool DUO-FAST DFCR175C. DUO-FAST DFCR175C 18 pages. Cordless roofing coil nailer

Print Page

Battery and Charging System

The Duo-Fast

Cordless tools come with a recharge-

able battery and its own charging system. This

charging system is the only one that will work with

Duo-Fast

batteries. The first step in preparing a

new tool for operation is to fully charge the battery.

New batteries are shipped discharged and must be

charged prior to first use.

Batteries will take 5 minutes to 2 hours (time will

be dependant on the amount of discharge of the

battery) to recharge.

Important Charging Notes

Battery Disposal:

TheDuo-Fast

batteries contain cadmium and must be

recycled or disposed of properly. It is illegal in some

areas to place a nickel-cadmium battery into the trash

or solid waste stream. You may contact your local

recycling center for information on where to return the

spent battery or call 1-800-822-8837 for information on

Ni-Cd battery recycling in your area.

Duo-Fast

Warning

CHEMICAL/EXPLOSION

HAZARD

Read ALL instructions be-

fore charging or using bat-

tery. Failure to follow ALL

instructions may result in

fire, severe burns, or re-

lease of toxic materials.

Battery and Charging System

Charging Instructions

1. Remove wall mount unit with the blue label from

the tool case and plug into a 120V AC outlet. Set

the black charger on a stable surface and insert wall

mount unit's plug into plug receptacle on the back

of the charger (see picture). A green light indicates

power is on and charger circuit is ready.

2. Remove the battery from tool or case and insert

terminals down into charger. The red light will come

on indicating that the battery is charging and the

green light will go out.

If battery is completely discharged, the red light and

the green light may flash back and forth.

This safety feature slowly recharges the battery

until it is ready to accept the full charging current.

If the red and green lights continue to flash after

5 minutes, replace the battery.

3. After charging is complete, the red light will go out

and the green light will come on, indicating that the

battery is fully charged. The charger will keep the

battery at full charge until it is removed.

4. Unplug the wall mount unit from the charger and

remove the wall mount unit from the 120V AC outlet.

CHARGING TIMES:

First charge (new battery)

Discharged Battery

CHARGING DON'TS:

1. Do not charge battery outdoors or in temperatures

below 40°F (5°C).

2. Do not allow metal objects to come in contact with

battery terminals.

3. Do not puncture or attempt to open battery case or

cells.

4. Do not store battery where it will be subjected to

temperatures above 120°F (49°C).

5. Do not incinerate battery.

6. Do not use a defective battery charger, one that

over-heats and/or smokes when plugged in.

7. Do not immerse the battery in water.

Charging System Accessories:

Battery - Part No. 902336

Battery Charger Kit - Part No. 902327

Wall Mount Transformer* - Part No. 902302

Battery Charger Base* - Part No. 902301

Automotive Adapter* - Part No. 902333

NOTE

2 hours

5 minutes to 2 hours