Duo-Therm GENESIS 3308120 Series Installation And Operating Instructions Manual - Page 8

Browse online or download pdf Installation And Operating Instructions Manual for Water Filtration Systems Duo-Therm GENESIS 3308120 Series. Duo-Therm GENESIS 3308120 Series 8 pages. Air filtration system

Print Page

G. Use Aluminum foil tape (not provided) to seal the ends of

the foam divider to the sides of the opening. Make sure

the area behind the flange on the ceiling template is

sealed. See Figure 9.

Use Aluminum Foil Tape To Seal the

FIG. 9

Foam Divider To The Sides of 14-1/4"

x 14-1/4" (±1/8") Ceiling Opening

Route wires

through Slot

Catch Flange In Groove Of

Return Air Cover

H. Install the slider in the return air cover and raise it to the

ceiling template. Route the wires from the return air

cover through the template slot leaving about 3" of wire

in between. Place the front of the return air cover against

the ceiling and slide towards the rear. The flange on the

ceiling template will catch in the groove on the return

cover. Adjust the position (right to left) and install the

front two screws. Start and tighten the remaining screws

to hold it in place. Connect together the DC wires (3

Black - negative and 3 Red - positive) from the supply,

control box and filter indicator. See figure 9.

Note: Number 10 cabinet screw can be used to replace

the two front screws, and pull the plastic return air cover

to the ceiling when the ceiling material is hard.

1. If solar panel is installed see instructions pack

aged with solar panel option.

Tighten the screws holding the return air cover. Slide the

filter from the right side (looking toward the RV front) over

the wires. Make sure the wires are above the filter and are

out of its way.

J. Place grill on return air cover and snap in place. Decal is

on end over circuit board.

K. Place slide handle through slots in grill into the slide

posts. Handle will fit in either direction. See Figure 10.

OPERATING

INSTRUCTIONS

GENERAL INSTRUCTIONS

A. Read your Control Systems Operating Instructions care-

fully before attempting to start your air conditioner.

B. The 3308120.XXX Genesis Air Filtration System is

designed to allow the unit to direct the air flow through the

RV's duct system; or, by opening a slide control the air

will be discharged directly out from the return air cover.

1. Slide the slide handle towards the front of the RV to

divert the air into the duct system.

2. Slide the slide handle to the rear of the RV and the air

will discharge out the return air cover.

3308120.XXX GENESIS AIR FILTRATION SYSTEM

Make Sure To Seal

Behind Flange

C. The "CLEAN FILTER" bulb will blink as a reminder to

clean/change the air filter every 60 days. If in dusty

conditions, the filter should be checked bi-weekly and

clean/changed if needed.

1. To clean the filter, remove the dust using a vacuum

cleaner. Wash filter with a mild detergent, rinse with

clean water and allow to dry.

NOTE: Replace filter annually. See your Duo Therm

Dealer for replacement filter. Filter part numbers are

stamped on filter frame.

2. To reset the "CLEAN FILTER" reminder:

a. Depress the gray button "FILTER RESET" on the

decal of the grill. The Light will blink 3 times to indicate

a successful reset. See Figure 11.

FIG.11

Push To Reset

Micro-Therm Filter System

FILTER

RESET

FIG. 10

Foam

Divider

Slide

Return

Air

Cover

Slide

Handle

FILTE R

RESE T

Light

Ceiling

Template

Filter

Grill