Free The Tone AS-1R Owner's Manual - Page 4

Browse online or download pdf Owner's Manual for Recording Equipment Free The Tone AS-1R. Free The Tone AS-1R 8 pages. Digital reverb

Print Page

Adjusting reverb (Manual mode)

The MANUAL LED above the MODE switch illuminates when the AMBI SPACE is operating in Manual mode.

In Manual mode, reverb sound is set by the position of each knob.

Adjusting reverb sound

1. Press the ON/OFF switch to illuminate the LED above it.

2. Turn the MODE encoder to select the desired reverb type.

3. Turn the MIX knob to adjust the mixture level between the original and reverb sounds.

4. Turn the TONE knob to adjust the tone of the reverb sound.

5. Turn the DECAY knob to adjust the decay time of the reverb sound.

6. Turn the PRE DELAY knob to adjust the delay to start feeding the reverb sound.

Reverb types

Use the MODE encoder to select one of the reverb types.

Simulates a spring reverb. Note that a real spring reverb does not have the PRE DELAY function but the

SPRING

AMBI SPACE is deliberately designed to enable this function.

PLATE

Simulate a steel plate reverb. Metallic sounds with extended highs can be obtained

ROOM

Simulates reverberations in a room. Natural and warm reverberation sounds can be obtained.

HALL

Simulates reverberations in a hall. Spatial and clear reverberation sounds can be obtained.

Reverb that can be used for sound effects or volume swell. Magnificent and pure reverberation sounds as

CAVE

if you are playing in a cave can be obtained.

Frequency bands of reverberation sounds will also change according to the complex reverberation pattern

SERENE

design. You can get pleasing reverberation sounds as if they were resonating from another space.

Trail Function

Trail Function You can set whether the reverberation sound will remain or not when you turn off the effects.

Press and hold down the MODE switch for 1.5 seconds.

• The MANUAL LED (green) above the MODE switch flashes twice and the Trail function is turned on.

Reverberation sound will remain when you turn off the effects. (Default)

•The PRESET LED (red) above the MODE switch flashes twice and the Trail function is turned off.

Reverberation sound will not remain when you turn off the effects.

NOTE

It is not possible to set this function for each preset independently. This setting is applied globally to all of the

presets. When you are switching presets, if the Reverb type of the newly selected preset is the same as that of the

previous preset, then the Trail function is applied in the same way as when turning off the effect. If the Reverb type

of the newly selected preset differs from that of the previous preset, then the reverberation sound is muted and

then the preset is switched regardless of whether the Trail function is turned on or off.

Recalling a preset (Preset mode)

When the PRESET LED above the MODE switch illuminates, the AMBI SPACE is in Preset mode. In

Preset mode, the reverb sound stored in the preset selected by the PRESET switch is recalled.

Switching between presets 1-4

1. Press the MODE switch to illuminate the PRESET LED.

2. Press the PRESET switch to select the preset.

NOTE

In Preset mode turning each knob does not change reverb sounds. Only the reverb sound in the preset is output.