Danfoss 176F1784 Instructions

Browse online or download pdf Instructions for Industrial Equipment Danfoss 176F1784. Danfoss 176F1784 5 pages. Usb extension cable into f-frame vlt drives

Print Page

INSTALLATION OF USB EXTENSION CABLE INTO F-FRAME VLT

This instruction sheet is for the field installation of the USB extension cable into the door

of F-Frame VLT frequency converters. Note: This kit is applicable to drives built dur-

ing or after Week 40 of 2008. Frequency converters built prior to Week 40, 2008 do not

have the provisions for this kit.

Kit Part Number

176F1784

The frequency converter contains dangerous voltage. Disconnect power and follow lock-

out/tag-out procedures before working on this equipment.

The door on the rectifier section of

F-Frame VLTs are fitted with a

feed-through hole to accommodate

a USB extension cord so that the

controls can be accessed from a

laptop computer without requiring

access to the inside of the VLT.

With the rectifier door open, the

hole is located near the upper right

corner of the door. See Figures 1

and 2.

The feed-through hole is covered

by the decorative label on the out-

side and with a round sticker on the

outside.

Instruction No: 177R0091 V0 Jan 2009

INSTRUCTIONS

Kit Contents

•

USB extension cord

•

Tie wraps

•

Instruction Sheet 177R0091

WARNING

Figure 1. Location of USB feed-through hole.

Page 1

VLT

is a registered trademark of Danfoss A/S

DRIVES