AudioControl LC7i Manual - Page 7

Browse online or download pdf Manual for Media Converter AudioControl LC7i. AudioControl LC7i 16 pages. Six channel line output converter with accubass for interfacing with factory installed audio systems

Print Page

Remote In: In some installations, you may not want to use

the GTO™ to turn on your system. For these cases the LC7i can

be turned on remotely with a +12-volt trigger. When you use the

+12-volt remote in, you should set the internal GTO™ jumper (see

"Under the Hood" on page 6) to "Defeat". This will prevent the

car's network system from turning the system on unexpectedly.

Remote Out: Supplies 12 volts "+" when the LC7i is pow-

ered up, and is used to turn on external devices like signal proces-

sors and amplifiers. Recommend fusing at 1 amp.

Maximized Indicator: This brightly colored LED indicates

when the signal level is just below clipping within your LC7i.

When properly level matched, this LED should flicker occasionally

when your system is playing at its maximum volume level.

Power: If you have connected all of your power wires cor-

rectly, this light should be bright red when your system turns on.

Optional (ACR-1) Dash Mounted Control Input: You can

add a dash control that allows you to set remotely the level of the

subwoofer.

Pre-Amp Outputs: These RCA plugs should be connected to

the next component after the LC7i, such as a crossover or ampli-

fier. Do not connect any speakers directly to your LC7i outputs.

Output Levels: These knobs allow you to adjust the signal

level from your source unit to match the input of your after-market

amplifiers. Ideally you want to keep the output of the LC7i high

and keep the amplifier gain(s) as low as possible.

Channel Summed Indicators: Under the cover of your LC7i

are jumpers that will allow you to sum selected channels into the

main (#1) channels. This is especially useful for factory-installed

systems with actively crossed over speaker systems. These indica-

tor LED's let you know which channels are being summed into the

main inputs.

page 7