Duplo DP-A100 II Installation Manual - Page 11

Browse online or download pdf Installation Manual for Disc Duplicator Duplo DP-A100 II. Duplo DP-A100 II 12 pages. Duprinter

Print Page

7. Replenishing Ink

Replenishing Ink

1. Accessing HELP mode:

Turn the power switch on while simultaneously

pressing the PRINT SPEED keys.

2. Accessing H-04:

Use the NUMERIC keys to enter 0 and 4.,

and then press the PRINT key.

The drum will rotate and the ink pump will

run.

When ink replenishment is completed, the

drum will stop with a beep-beep-beep tone.

It takes approximately 30 seconds to

complete ink replenishment.

3. Turn the power off, and then turn it on again.

4. Perform master making and printing.

Refer to the Instruction Manual for more

details.

IMPORTANT

The image will be light until ink is fully spread

over the drum surface. (Continuously print

approx. 20 pages.)

5. Once ink is fully spread, check the printed

image. If the density varies between the

near and far areas of paper, make adjustment

according to Adjusting Ink Amount.

Adjusting Ink Amount

1. How to adjust ink amount of the knob on the

rear side:

1.1 Lift the stopper of the drum and rotate the

drum by hand so that the master clamp

is located at the top.

Stopper

1.2 Loosen one screw to displace the cover.

IMPORTANT

● After the adjustment, move the cover

back to its original position and secure it

with the screw.

Ink adjusting

knob on the rear side

Ink adjusting knob on the operator's side

Master clamp

Cover

Screw