Brainwavz 3M VHB Fittings Manual

Browse online or download pdf Fittings Manual for Racks & Stands Brainwavz 3M VHB. Brainwavz 3M VHB 2 pages. Laptop & device mounts

Print Page

FITTING GUIDE

LAPTOP & DEVICE MOUNTS

Installation Guide

3M™ VHB™ Tape Mounting Guide - use for smaller and lighter devices only - max weight 1.5 kg

Place the brackets and your device on a flat surface and

measure the total width (A). Now mark these measurements

on your prepared surface. (B)

Peel off the red backing paper (A) and carefully press the

two side brackets firmly into place.

To ensure a more secure bond has been achieved, do not

use your new hanger for at least 24 hours after installation

or the hanger may fall down.

minutes is 50%, 24 hours is 90% and 72 hours is 100%.

minutes is 50%, 24 hours is 90% and 72 hours is 100%

Safety Guidelines

Screws are highly recommended when mounting laptops and other heavy or fragile items.

When mounting onto hollow/cavity furniture we recommend using 3M™ VHB™ tape

and screws for extra security.

Before screwing the brackets into place ensure your chosen surface is solid and a

minimum of 17 mm thick.

Take care when removing 3M™ VHB™ tape from any surface as it may cause

damage.

Always use the screw caps provided - DO NOT over-tighten screws.

In case of any problems please contact us by email:

Stick protective foam pads into the cut-out sections on the

Bond strength at 20

hanger (A) Stick the third bracket in place to act as a back-

stop, and protect your device from sliding too far back (B).

For illustration only - your hanger may differ from one shown