Daniela DDW300S User Manual - Page 5

Browse online or download pdf User Manual for Dishwasher Daniela DDW300S. Daniela DDW300S 6 pages. Domestic dishwasher

Print Page

Energy Saving Tips

-It is important to try and run the dishwasher when it is fully

loaded in order to save on energy. In order to prevent odors

from forming and food from caking onto the dishes, you can run

the soak cycle.

-Choose the right wash cycle: the choice of cycle depends on

the type of dishware, cookware and utensils being washed and

how dirty they are.

How to keep Your Dishwasher in Shape

After Every Wash

After every wash, turn off the water supply to the appliance and

leave the door slightly ajar so that moisture and odors are not

trapped inside.

Remove the plug

Before cleaning or performing maintenance, always remove the

plug from the socket. Do not run risks.

No solvents or Abrasive Cleaning Products

To clean the exterior and rubber parts of the dishwasher, do not

use solvents or abrasive cleaning products. Rather, use only a

cloth and warm soapy water.

To remove spots or stains from the surface of the interior, use a

cloth dampened with water and a little while vinegar, or cleaning

product made specifically for dishwashers.

Cleaning and Special Maintenance

Filter Assembly

For best performance and results, the filter assembly must be

cleaned frequently.

The filter efficiently removes food residue from the wash water,

allowing it to be recirculated during the cycle. For this reason, it

is a good idea to remove the larger food particles trapped in the

filter after each wash cycle by rinsing the "A" semi-circular filter

and cup under running water. To remove the filter assembly, pull

on the cup handle in an upward direction. The entire filter assem-

bly (made up of the "A" semicircular filter and the "B" fine filter)

should be cleaned at least once a week.

To clean the filter and the fine filter, use a cleaning brush. Then,

reassemble the filter parts as shown in the figures below and

reinsert the entire assembly in the dishwasher, positioning in its

seat and pressing downward.

The dishwasher must never be

used without the filters. Improper

replacement of the filters may re-

duce the performance level of the

appliance and damage dishes and

utensils.

-Use the right amount of detergent: if you use too much deter-

gent, the result will not be cleaner dishes, but, rather, a greater

negative impact on the environment.

When You Go on Holiday

When you go on holiday, it is recommended that you run a wash

cycle with the dishwasher empty and then remove the plug from

the socket, turn off the water supply and leave the door of the

appliance slightly ajar. This will help the seals last longer and

prevent odours from forming within the appliance.

Moving the Appliance

If the appliance must be moved, try to keep it in a vertical position.

If absolutely necessary, it can be positioned on its back.

Seals

One of the factors that cause odours to form in the dishwasher is

food that remains trapped in the seals. Periodic cleaning with a

damp sponge will prevent this from occurring.

Cleaning the Spray Arms

Check the spray arms periodically and clean them when

needed.

Cleaning the Water Inlet Filter

Periodically clean the water inlet filter (see figure) located on the

outlet of the water supply tap.

After turning off the water tap, unscrew the end of the water sup-

ply hose, remove the filter and clean it carefully under running

water. Then, return the filter to its place and tighten the water

supply hose back into position.

.7.

Troubleshooting

If the dishwasher does not function or does not function properly.

Before calling for assistance, check to see what can be done

first: have you forgotten to press one of the buttons or to per-

form an essential operation?

The Dishwasher Does Not Start

Have you checked whether:

- the plug is pushed into the socket correctly;

- the power is on in the house;

- the door is closed properly;

- the ON-OFF switch is on "ON";

- the water supply is turned on.

The Dishwasher Does Not Fill With Water

Have you checked whether:

- the water is turned on and the hose is connected properly;

- the water supply to the house is on and has sufficient pressure;

- the water supply hose is crimped or bent;

- the filter in the water supply hose is clogged.

The Dishes Are Not Clean

Have you checked whether:

- Dishwasher was loaded properly. Jets of water could not reach

all parts of the dishes, etc;

- Too many items in the rack;

- Items in the rack were touching each other;

- Not enough detergent was added to dispenser;

- Selected wash programme was intensive enough;

- Rotation of spray arm was obstructed by dish, etc;

- Nozzles in spray arm are blocked by remnants of food;

- Coarse or fine filter or microfiller is blocked;

- Filters have been incorrectly fitted;

- Drain pump is jammed;

The Dishwasher Does Not Drain

Have you checked whether:

- the drain hose is crimped or bent.

Lime Deposits or a White Film Form on the Dishes

Have you checked whether:

- the rinse aid dosage is correct.

Error Messages

The dishwasher is equipped with a safety system that is able to

detect operating problems and malfunctions. These malfunctions

are signalled by the rapid blinking of one of the "M" program LEDs.

Only in the case where the indicator light for the soak cycle (see

table for cycles) blinks rapidly should you cancel the cycle as

described in the section entitled, "Changing a Cycle while Under-

way." Then check to make sure that there is water in the mains

and that the tap is turned on. If the problem continues, call for

technical assistance, indicating which light was flashing.

If any of the other indicator lights begin to blink rapidly, turn off

the appliance and call for technical assistance, advising which

lights were flashing.

If, despite all these checks, the dishwasher still does not function

and/or the problem persists, contact the nearest authorised ser-

vice centre and provide them with the following information:

- the nature of the problem;

- the model number AND

serial number, which are on the plate located

on the side of the inner part of the door.

Never call on unauthorised technicians and refuse to

allow parts to be installed that are not original spare

parts.

.8.