Dura Trel 11146 Installation Instructions

Browse online or download pdf Installation Instructions for Fencing & Gates Dura Trel 11146. Dura Trel 11146 4 pages. Courtyard arbor gate

Print Page

TOOLS NEEDED

Drill with 3/32",5/32"Bits

and Phillips Screw Bit

Or Phillips Screwdriver

Hammer

Ruler

GATE INSTALLATION

Gate panels are to be installed approximately 3" from ground level, leaving a ½" gap between the

outside of the gate and the 4 x 4" post of the arbor. To make installation easier, place 3" blocks

under gate panels to ensure proper, level installation. Attach gate hinges to posts and gate panel

according to package direction and using diagram above for placement.

With gate in place, attach the gate latch on outside of the gate panels (same side as hinges),

approximately 4" from the top of the 2 x 2" gate panel post.

Your gate comes with a 12" cane bolt kit to make one side of the gate stationary if desired. Attach

the cane bolt to the backside of one of the gate panels as shown on package. Drop the slide to the

ground, mark area where the slide meets the ground. Clear away a small hole around the end of

the slide approximately 2" deep. Insert the 5/8 x 6" anchor tube into ground, with top of tube at

ground level. To keep one side of the gate stationary, simply slide the 7/8 x 1 ½" slide in gate post

over the anchor tube.

These instructions show recommended installation for the design of the gate kit.

If you encounter missing or defective parts, please contact manufacturer direct at toll free # below.

Dura-Trel, Inc. ~ PO Box 122, Sheboygan Falls, WI 53085 ~ Toll Free 877-258-6020

#11146 C

OURTYARD

installation INSTRUCTIONS

RBOR

ATE