AUDIOLINE TEL5 clip Operating Instructions Manual - Page 8

Browse online or download pdf Operating Instructions Manual for Telephone AUDIOLINE TEL5 clip. AUDIOLINE TEL5 clip 16 pages.

Print Page

Setting up

3.1

Safety Information

Caution: Before setting up, it is essential that you

read the General Information at the beginning of

this manual.

3.2

Check contents of pack

The following items are supplied:

one telephone base

one telephone connecting

cable

one instruction manual

3.3

Connecting the receiver

After unpacking your telephone, you must first connect the

telephone receiver to the telephone base. First take one end

of the spiral cable and plug it into the socket at the bottom of

the receiver. Turn the telephone over and plug the other end

into the lower socket (see Chapter 2, Section entitled

Underside of base unit, Item 4.). Bring the cable out via the

cable duct.

3.4

Fitting the batteries

Before connecting your new telephone to the telephone

network, the batteries should be fitted. Please always use a

good type of AA batteries. No messages will be shown in the

display if the batteries are not fitted. Before installing or

changing the battery, make sure that the telephone is not

connected to the telephone network.

1. The battery compartment is to be found on the

inside of your telephone base.

2. Open the battery compartment with a small

screwdriver or a pointed object.

3. Insert the batteries, ensuring that the polarity is

correct.

4. Close the battery compartment.

The battery should be changed when the \ symbol

appears in the display. All three batteries must then be

changed. If the batteries become discharged, the display will

go dark.

3.5

Connecting the telephone

Connect the telephone cable supplied to the telephone

socket and the telephone jack on the underside of the

− Setting up −

one telephone receiver

one spiral cable

three AA batteries