Danita APA100 User Manual - Page 4

Browse online or download pdf User Manual for Security System Danita APA100. Danita APA100 8 pages. Superguard alarm system

Print Page

UK User Manual

In General:

danita APA100 is a pager system to be used both as a calling system and

an alarm system. The system consists of a transmitter with an antenna and

a receiver.

Four different indications can be transmitted. Thus it will be possible to

read directly from the receiver where the signals comes from. Depending

on the mounting you may e.g. be able to see if it is a door or the bonnet

which is being opened. In your home you can see which door is opened

and at the ofﬁce you can see which room you will have to go to when you

are called for. Only your fantasy will set the limits to the possibilities of

applications.

1. Red + 10-25 VDC (+ trig connect to + for action)

2. Black - (Chassis) (- trig connect to - for action)

3. Brown - trig. Green light at the receiver. (150mS trig time)

4. Grey - trig. Red light at the receiver. (450mS trig time)

5. White IGN. If connect to + DCV the transmitter is blocked.

After removing it takes 30 seconds before trig is active again.

6. Blue + trig. Yellow light at the receiver. (450mS trig time)

7. Green - trig. Yellow light at the receiver. (30mS trig time)

8. Yellow -trig. Alternating light. Yellow, green and red. (75mS trig time)

9 + 10. Orange. Out of range alarm. Gives quick shift with red and green

light. Attention: Set the receiver up for same mode.

Comes from factory in standard mode. Orange wire is intact.

If "Out Of Range" wanted, cut the orange wire.

From serial number E1001Rxxxxx.

Push knob on the transmitter box gives alternating light.

Mount the antenna to the BNC connector. The antenna should not be

mounted close to metal, as it will limit the transmitting range.