3xLogic VISIX 360 Hardware Installation Manual - Page 6
Browse online or download pdf Hardware Installation Manual for Security Camera 3xLogic VISIX 360. 3xLogic VISIX 360 16 pages. 3xlogic visix 360 network camera
Also for 3xLogic VISIX 360: Installation Manual (16 pages)
Print Page
Cautions:
Make sure the power supply voltage is correct before using the camera.
Do not drop the camera or subject it to physical shock.
Do not touch sensor modules with fingers. If cleaning is necessary, use a clean cloth with a bit of ethanol and
wipe it gently. If the camera will not be used for an extended period of time, put on the lens cap to protect the
sensor from dirt.
Do not aim the camera lens at the strong light such as sun or incandescent lamp. The strong light can cause
fatal damage to the camera.
The sensor may be burned out by a laser beam, so when any laser equipment is being used, make sure that
the surface of the sensor not be exposed to the laser beam.
Do not place the camera in extremely hot, cold temperatures (the operating temperature should be between -
30°C ~ 60°C, or -40°C ~ 60°C if the camera model has an "H" in its suffix), dusty or damp environment, and do
not expose it to high electromagnetic radiation.
To avoid heat accumulation, good ventilation is required for a proper operating environment.
Keep the camera away from water and any liquid.
While shipping, the camera should be packed in its original packing.
Improper use or replacement of the battery may result in hazard of explosion. Please use the manufacturer
recommended battery type.
Notes:
For cameras that supports IR, you are required to pay attention to the following precautions to prevent IR
reflection:
Dust or grease on the dome cover will cause IR reflection. Please do not remove the dome cover film until the
installation is finished. If there is dust or grease on the dome cover, clean the dome cover with clean soft cloth
and isopropyl alcohol.
Make certain the installation location does not have reflective surfaces of objects too close to the camera. The
IR light from the camera may reflect back into the lens causing reflection.
The foam ring around the lens must be seated flush against the inner surface of the bubble to isolate the lens
from the IR LEDS. Fasten the dome cover to camera body so that the foam ring and the dome cover are
attached seamlessly.
10225 Westmoor Drive, Suite 300, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC
Hardware Install Manual | VISIX 360 Network Camera
6