Conrad-Johnson MV45 Owner's Manual - Page 8
Browse online or download pdf Owner's Manual for Amplifier Conrad-Johnson MV45. Conrad-Johnson MV45 8 pages. Vacuum tube power amplifiers
Print Page
SPECIFICATIONS
MV75:
Power:stereo: 75 watts per channel, minimum RMS at 4, 8, or 16 ohms from 30Hz to
15kHz, with no more than 1% total harmonic distortion or intermodulation distortion.
monaural: 150 watts minimum RMS at 4 or 8 ohms from 30Hz to 1kHz, with no
more than 1% total harmonic distortion or intermodulation distortion.
Frequency Response: 20Hz to 20kHz to -.5db
Signal to noise ratio: 90 db
Tube complement:
MV45
Power: 45 watts per channel, minimum RMS at 4, 8, or 16 ohm from 30Hz to 15kHz,
with no more than 1% total harmonic distortion or intermodulation distortion.
Frequency Response: 20Hz to 20kHz to -.5db
Signal to noise ratio: 90 db
Tube complement:
SERVICE
If service becomes necessary, the amplifier may be either returned to your dealer or
sent to conrad-johnson for service. In either case, a written description of the
difficulties encountered should be provided by the owner. To ship the amplifier,
MV75: remove the entire rack panel and protective cover assembly by removing the
switch nut and three machine screws from each side of the chassis. Next remove,. and
separately box, the tubes. The amplifier chassis and the set of tubes must be packed
in the original factory carton and packing materials. The amplifier should be shipped
without its rackplate and cover.
MV45: remove the protective cover by removing two screws on each side of the
chassis. Next remove and separately box the tubes in their individual boxes. Pack
the boxed tubes into the tube carton and box the amp in its original factory carton and
packing materials. (Shipping cartons and packing materials are available from
conrad-johnson at a nominal charge.) Ship by United Parcel Service (UPS) to:
1 5751, 2 6CG7, 4 6550
1 5751, 2 12AT7, 4 6CA7/EL34
conrad-johnson design, inc.
Service Department
2733 Merrilee Drive
Fairfax, Virginia 22031