DANLERS PORF S8A Installation Notes - Page 2

Browse online or download pdf Installation Notes for Switch DANLERS PORF S8A. DANLERS PORF S8A 2 pages. Radio receiver switches

Installation procedure
1. Please read these notes carefully before commencing work.
In case of doubt please consult a qualified electrician.
Make sure the power is isolated from the circuit.
2. The radio receiver switch should be connected as:
L
Live
N
Neutral
SL
Switched line output (CERF: Kilk-AX socket 'A' terminal)
3.Typical wiring diagrams and mounting details are shown below.
4. EX RFS: unit should be fixed using only the pre-drilled mounting holes
and 6-12mm diameter circular cables used. If IP65 rating not achieved
then drain-hole guide on lower face of box should be carefully drilled
through with 4mm drill to max depth of 10mm, enabling IP54.
5. Once the wiring has been completed and verified, switch on the supply
and program the radio receiver switch to the appropriate senders.
Installation diagrams
WACE RFS, CEFL RFS, DIN RFS, CEVO RFS(6A) EX RFS
Wiring diagram
SL
L
L
optional wall switch
for overriding off
N
radio
receiver
230 VAC
switch
load
N
CERF S6A
Wiring diagram
CERF S6A
L N SL
lighting socket
'A'
L
230 VAC
load
N
Wiring diagram
EX RFS
L N SL
L
230 VAC
load
N
isolation
switch
CEFL RFS
Mounting details
Springs closed
Springs opened out
Cut-out hole
63 or 64mm (2.5") diameter
Programming procedure
If you have a pre-programmed radio receiver switch please do
not attempt to reprogram it.
Each radio receiver switch can be programmed to respond to up to
15 senders as outlined below. To assign a slave sender please refer
to the installation notes received with the slave sender.
CEFL RFS and WACE RFS have a single programming hole, other
units also have a smaller LED hole.
WARNING: Do not probe the smaller LED hole.
Needed: A small screwdriver to 'Press' the internal programming
button of the radio receiver.
Notes:
'Quick Press' - less than half a second,
'Wait Press' - until next step is completed.
To 'Quick Press' or 'Wait Press' the manual sender use
either the up or down button.
Ensure the radio receiver switch is powered.
WARNING: The EX RFS must be open whilst programming, the
terminals will be LIVE.
WARNING: If a load is connected during programming it will be
switched on when the LED is on.
To assign a Manual Sender
1 'Quick Press' the radio receiver - LED switches on
2 'Quick Press' the manual sender - LED flashes off twice
To assign more senders repeat step 2
3 'Quick Press' the radio receiver - LED switches off
To de-assign a Manual Sender
1 'Quick Press' the radio receiver - LED switches on
2 'Quick Press' the manual sender - LED flashes off twice
To de-assign more senders repeat step 2
3 'Quick Press' the radio receiver - LED switches off
To de-assign all Senders
1 'Quick Press the radio receiver - LED switches on
2 'Wait Press' the radio receiver until LED flashes off five times
3 Wait for 5 seconds - LED switches off