belavi 21224-22 User Manual - Page 5

Browse online or download pdf User Manual for Outdoor Furnishing belavi 21224-22. belavi 21224-22 17 pages. 10 foot offset umbrella

Print Page

*Please see descriptions for individual pieces that make up each part

found within the following illustrations to better understand the

instructions to complete assembly.

Fig.1

Push Pin

Canopy

Arm

Crank

STEP 2:

Place the Umbrella Frame (A) in the correct orientation as illustrated above,

with the pole placed in between the umbrella canopy, and the canopy

arm. Turn the crank handle clockwise until the line inside the canopy arm

tightens, see Fig. 1. Connect the two ends of the canopy arm together using

the push pins found on either side of the canopy arm, see Figure 1. Use the

push pins to connect the top of the umbrella canopy to its housing, see

Fig. 2 & 3.

Assembly Instructions

Housing

Fig.2

Fig.3

Push Pin

Umbrella

Canopy

Pole

*Place a counterweight such as an offset umbrella base (not

included) that can be filled with water or sand, or triangular

weight bases (not included) before proceeding further. An offset

umbrella base should be able to hold 100lbs. of sand or water,

or 4 triangular weight bases, minimum 25lbs. each. This is the

recommended amount of weight to maintain product stability,

especially while umbrella canopy is open.

Band

STEP 3:

Place the pole of the Umbrella Frame (A) inside of the Bottom Pole (B)

so that the prongs fit within groves at the top of part B, see Fig. 4. Insert

Locking Knob (E) through band found at the top of part B, and bolt-

threading of this part, see Fig. 4. Tighten the Locking Knob (E) until

pressed against the pole of the Umbrella Frame (A) enough to hold

it in place, see Fig. 5. Over tightening may dent or chip away at the

protective coating of the Umbrella Frame (A).

Assembly Instructions

Prongs

Fig.4

Fig.5