Belcat CADIC-2 User Manual - Page 2

Browse online or download pdf User Manual for Amplifier Belcat CADIC-2. Belcat CADIC-2 3 pages.

Print Page

INSTALLATION MANUAL

1. Contents

Chromatic Tuner

Low

Batt.

TUNER

BRIGHT

2. Battery

MIDDLE FREQ.

Box

PHASE

NOTCH

VOLUME

1. Preamp

2. Tool

1. Electric Drill

2. Drill Bit

(2.3mm or 3mm)

3. Phillips Screwdriver

3. Insert EQ and battery box into hole of guitar.

4. Fasten screws properly.

6.Installing the pick-up

Pick-up

wire

3. Pick-Up

4. Clip

5. Screw

4. Router and Grinder

(cutting-edge 3mm)

5. Round File

6. Masking Tape

5. Put plugs

into jacks.

1. Cut out the hole with template

Cutting

Masking

Template

Tape

Preamp

2.Drilling hole for pick-up

8. Fix wire with clip

Clip

Pick-up

Wire

Solution

1) When there is no sound or sound is stopped,

- Check guitar cable, amp or Mixer

- Check if there is batter or not. When it happens noise or distortion,

please exchange battery.

- Check if the pickup and battery connector is connected correctly

or not.

- Check if out put jack is connected correctly.

2) When there is hum-noise,

- Check the pickup is connected well or not.

- Check if the connectors are connected to correct position well

or not.

3) Some causes of the balance problem

- When the bottom of saddle or the groove of saddle is not flat.

- When saddle is installed to the groove of saddle loosly.

- When the connection is not good between the bottom of saddle

and the groove of saddle.

- When Saddle is very short

- When there is grounds on the groove of saddle.

- When Saddle is declined toward front or back.

- When the top of guitar is bended.

- When the pickup is installed to only a part of the groove of saddle.

(back page)

Masking

Tape

Cutting

Template

Battery Box

Battery box

Cable

Battery

Box