casmar CSM-108R Quick Start Manual - Page 3
Browse online or download pdf Quick Start Manual for Receiver casmar CSM-108R. casmar CSM-108R 3 pages. 08ch active cat5 video receiver/hub
Print Page
- Wire Type: Network Wiring One Unshielded Twisted Pair 24-16 AWG
(0.5-1.31mm). Category Type Cat 5 or better. Impedance 100±20 ohms.
- DC Loop Resistance 52ohms per 1,000 ft (18 ohms per 100m).
- Differential Capacitance 19pF/ft max (62pF/m max).
- LED Indicator: Power On Red Indicator LED Light.
- Power Supply: +12VDC/1A
Environmental
Temperature -20°C to +65°C.
Humidity (non-condensing) 0 to 95%.
Transient Immunity
6,000 V 1.2µS x 50 µS per ANSI/IEEE 587 C62.41 B3.
3,000 V 8µS x 20 µS when ground screw terminal is bonded to earth-ground.
Equipment Installment
1: Put the video signals you need in the VIDEO IN/OUT of CAT5 Video
Transceiver.
2: Put a twisted-pair in the VIDEO A, B screw terminals of CAT5 Video
Transmitter and Receiver respectively.
3: Connect with the mains following instructions shown in the system
configuration diagram or sketch map, make sure DC power supply is
+12VDC/1A.
4: Set the position of ADJ correctly according to the distance table in
Transceiver.
5: 3 'GND' screw terminals are bonded to earth-ground.
6: After the five steps, the 08 VIDEO Outputs of 08 Channel CAT5 Video
Receiver/Hub is ready to work.
Check after Connection
1. Power On Red Indicator LED Light.
2. Make sure that UTP wire and coaxial cable is correctly and firmly connected.
3. Make sure the 'GND' screw terminal is firmly connected to earth-ground.
Mechanical
Dimensions: 326X120X33mm
Material: Metal Housing Case