Danner 03800 Assembly Instructions

Browse online or download pdf Assembly Instructions for Outdoor Fountain Danner 03800. Danner 03800 2 pages.

Print Page

Halo

ITEM # 03802

Fig. A

STEP 1

MAKE SURE THE "FLOW CONTROL" ON THE PUMP IS IN THE FULLY OPEN POSITION.

WITH THE PUMP IN THE UPRIGHT POSITION, THE SLIDING STEM ON THE FRONT OF

THE PUMP COVER SHOULD BE SLID ALL THE WAY OVER TO THE LEFT. IF NOT, DO SO

BEFORE INSTALLING. (Fig A)

STEP 2

ATTACH THE PLASTIC FITTING INTO PUMP OUTLET (Fig A)

STEP 3 (Halo and Aura only)

EXTENDING FROM THE BASE OF THE FOUNTAIN. PUSH UNTIL SNUG (Fig B)

STEP 3a (Pearl only)

FROM THE BASE OF THE FOUNTAIN. PUSH UNTIL SNUG (Fig C)

STEP 4

ATTACH THE PUMP (with plastic tting installed) INTO THE LONGER PLASTIC TUBE

EXTENDING FROM THE BASE OF THE FOUNTAIN. (Fig D)

STEP

PLACE THE PUMP INTO THE BASIN, MAKING SURE THAT THE PUMP CONNECTOR

REMAINS OUTSIDE THE BASIN, AND PLACE THE FOUNTAIN ON TOP OF THE BASIN. BE

SURE TO PLACE BASIN ON LEVEL SURFACE.

STEP 6

PLUG THE MALE L.E.D. BARREL CONNECTOR INTO THE MATING CONNECTOR COMING

OUT OF THE PUMP. (Fig E)

BE SURE THIS CONNECTION REMAINS OUTSIDE THE WATER. THE CONNECTION

SHOULD BE VISIBLE AFTER MOUNTING THE FOUNTAIN ONTO THE BASIN.

STEP 7

PLUG THE MALE BARREL CONNECTOR ON THE 6 FT. LONG CORD INTO THE A.C. WALL

ADAPTER

STEP 8

FILL THE BASIN WITH WATER UNTIL IT REACHES THE BASE PLATE OF THE FOUNTAIN.

STEP 9

ADD DECORATIVE ROCKS INCLUDED WITH FOUNTAIN TO TOP OF BASE PLATE.

STEP 10

INSTALL CRYSTAL BALL INTO CENTER CAVITY OF FOUNTAIN (Fig F)

STEP 11

PLUG A.C. WALL ADAPTER INTO OUTLET. BE SURE TO LEAVE A "DRIP LOOP" IN THE

WIRE. (SEE FIG. 1 ON OPPOSITE PAGE)

NOTE:

Allow a minute for water to ow. If water ow does not start, unplug and

refer to STEP 1 and check that ow control is open position.

The following instructions will assist you in assembling your particular fountain.

Depending on which fountain you have purchased there will be slight

Aura

Fig. B

INSERT THE L.E.D. INTO THE SHORT PLASTIC TUBE

SLIDE THE L.E.D. RING OVER THE SINGLE PLASTIC TUBE EXTENDING

Assembly Instructions

variations in how they get assembled.

ITEM # 03801

Fig. C

Fig. D

Pearl

ITEM # 03800

Fig. E

Fig. F