Console Customs XBOX Series MAXFIRE-SXS RAPID FIRE Instruction Manual - Page 4

Browse online or download pdf Instruction Manual for Video Gaming Accessories Console Customs XBOX Series MAXFIRE-SXS RAPID FIRE. Console Customs XBOX Series MAXFIRE-SXS RAPID FIRE 5 pages.

Print Page
Console Customs XBOX Series MAXFIRE-SXS RAPID FIRE Instruction Manual
R
EFLEX REMAPPING BUTTONS
Reflex remapping buttons are optional buttons or paddles on the back of the controller which can be assigned to a standard controller button. These buttons
can also be made turbo. See the programming mode instructions below for more information.
P
ROGRAMMING MODE
Within the programming mode you can setup the reflex buttons, change the rapid fire speed and change the burst fire shot amount.
Enter the programming mode:
Exit the programming mode:
Change Rapid Fire Speed:
To change the rapid fire speed you only need to TAP UP or DOWN on the D-pad. UP to make the speed faster and DOWN to make it slower. The LED will flash
when increasing or decreasing. Once you have reached the MIN or MAX speed the LED will no longer flash.
Change Burst Fire Quantity:
To change the number of shots fired with the burst fire you must TAP LEFT or RIGHT on the D-pad. Left for fewer shots and Right for More shots.
Check Rapid Fire Speed Setting:
To check the currently set rapid fire speed you only need to TAP Y. The LED will make long flashes for the "tens" position and then short flashes for the single
digit. (example: 3 long flashes, followed by 6 short, you are now at speed setting 36) Refer to the table below for all of the speed setting options.
Check Burst Fire Setting:
To check the currently set burst fire setting just TAP A. The LED will flash 2-10 times to indicate the number of shots set for the burst fire.
Reset Current Mode to Default Settings:
To reset the rapid fire mode you are currently editing to the factory default you must HOLD X and B together for 7 seconds. After 7 seconds the LED will flash
very fast 20 times to indicate the Mode has ben reset.
Change Reflex Button Mapping:
HOLD one of the Reflex buttons and TAP the button you want to assign to it. The LED will flash 1 time to confirm your change. If you tap the controller button
which is already assigned to the reflex button, this will disable the button and the LED will flash 3 times. The button will then not do anything when pressed
until it is reassigned to a new controller button.
Set Reflex Button to Turbo Speed:
Double tap the reflex button to cycle through the 5 speed settings listed below. The LED will flash 1-5 times to indicate the setting.
1. No Turbo
2. Turbo at the currently set rapid fire speed
Rapid Fire Setting
10
11
12
HOLD RT + RB + LT + LB for 8 seconds, the LED will make one long flash.
Tap VIEW
TAP
RAPID FIRE SPEED SETTINGS
Shots Per Second
1
40
2
30
3
25
4
20
5
18
6
16
7
14
8
12.5
9
11.35
10.4
9.6
9
3. Fixed 5sps turbo
4. Fixed 10sps turbo
Rapid Fire Setting
13
14
15
16
17
18
19
20
21
22
23
24
HOLD ALL FOR 8 SECONDS
5. Fixed 15sps turbo
Shots Per Second
8.33
7.8
7.35
7
6.5
6
5.5
5
4.5
4
3.5
3