CASO DESIGN HW 400 Original Operating Manual - Page 13

Browse online or download pdf Original Operating Manual for Water Dispenser CASO DESIGN HW 400. CASO DESIGN HW 400 16 pages. Instant boiling water dispenser

2. Setting of Temperature
Plug in the power plug and place a cup or similar on the cover of drip tray. Then set the
desired temperature. Switch on the device, the lamp lights up in green.
The water is heated and flows into the cup. Switch the device off, when the desired amount of
water has been dispensed.
Please note
► If device was not used for long periods of time, there could be scale deposits despite water
filter. In this case let 4 fl oz with 212 °F run through the device.
► The ambient temperature changes everyday. This leads to different amounts of water. It
can vary up to +- 15%.
3. Water disposal from the drip tray
1. When the drip tray is full, grasp and stabilize the
appliance by one hand and use the other hand to
lift up the drip tray slightly to remove it.
2. Remove the cover of drip tray.
3. Empty the drip tray, replace cover of drip tray, and
insert it into the original place. Make sure it is
properly inserted.
4. Replacing the filter
1. Open the tank cover and take out the box with the filter.
2. Soak the filter upright in water for 10
min.
3. Rinse the filter under running water
for 10 sec.
4. Remove the old filter and replace it
with a new filter (see fig.). Take out
the filter box, place the new filter and
pull it down from the bottom.
13