Audiopipe APMR-4080MIN Owner's Manual - Page 4

Browse online or download pdf Owner's Manual for Amplifier Audiopipe APMR-4080MIN. Audiopipe APMR-4080MIN 10 pages. Mini design mosfet marine amplifier

Print Page

English

This section suggests Mounting and Wiring Precautions for installing the Audiopipe marine

amplifier. If you do not posses the necessary tools and installation experience, do not

attempt to install this marine amplifier. Instead, contact your local Audiopipe dealer to

perform the installation.

Prior to mounting the marine amplifier, make sure it is safe to mount the marine amplifier

in that location. Failure to do so can result in serious damage to the boat. In addition,

stainless steel hardware should be used to mount the marine amplifier and additional

accessories. When possible, use a nut and bolt with a lock washer to secure the marine

amplifier. Extra care and attention is necessary in marine installations due to the uncertainty

of water conditions.

Additional precautions and suggestions:

For the most efficient cooling, mount the marine amplifier so cool air runs along the

length of the heat sink, rather than across them. To increase air movement and circulation,

a cooling fan can be installed.

Mount the marine amplifier on a rigid surface; avoid mounting to subwoofer enclosures

or areas prone to vibration.

Prior to drilling and holes, make sure the proposed mounting holes will not cut into the

fuel tank, fuel lines, electrical wiring, or through the boat.

Do not mount the marine amplifier where it is susceptible to water.

When bridging two amplifiers please refer to the bridging wiring chart.

When bridging two amplifiers you should use same model amplifiers.

Please make sure the negative speaker terminal of two amplifiers are connected by

the same gauge cables as the positive terminal being used.

DO NOT connect any signal cables with the input RCA jacks when bridged as slave

unit.

The LPF, Input level and remote functions will be disabled on slave amplifier when

bridged.

All the functions of the slave amplifier will be adjusted by the master amplifier.

- 3 -