Audiopipe DJAP-615P User Manual - Page 9

Browse online or download pdf User Manual for Speakers Audiopipe DJAP-615P. Audiopipe DJAP-615P 16 pages. Djap series hybrid portable pa system

Print Page

50. AF-LEVEL Indicator

These LEDs indicate the incoming status of the audio signal. The four green LEDs light up indicate normal condition. When the

audio signal from microphone approaches clipping level the red LED indicator lights up, If no LED lights up, there is little or even

no signal being received.

51. MIC. ON & Diversity Signal Indicator

These indicators light up during standby. When microphone signal is received, the A or B signal indicator lights up to indicate the

reception of microphone.

52. MIC. ON

The LEDs indicate the reception of microphone 1 and microphone 2 alone.

53. POWER ON Indicator

When the unit powered on, this blue LED will lights up. It indicates the receiver is on.

54. SQUELCH Control

This control is SQ noisy controlled adjustment. The job of squelch circuit is to reduce audible noise. It eliminates noise during

pause in the audio signal by muting the receiver. Before you turn on the receiver, please adjust SQ control until the jamming

signal has disappeared. (Clockwise)

55. VOLUME Control

This knob sets the output audio signal level. Turn the knob fully clockwise for the maximum volume; and turn the knob fully

counterclockwise for the minimum volume.

56. TO CH1 & TO MAIN Switch

From this switch you can choose the microphone signal sent to CH1 or to MAIN. Switching it to "TO CH1"position, the signal

will come through CH1, after it is adjusted by the 3-band

EQ and DSP/FX control, then sent to main channel, you

can also adjust the signal by using the 7-band graphic

EQ and the DSP processor, then sent to the MAIN OUT.

Switching it to "TO MAIN" position, the signal will only

go to the main channel, after adjusted by the 7-band

graphic EQ and the DSP processor, then sent to MAIN

OUT.

57. MIC1 TO CH1/MIC2 TO CH2 & TO MAIN Switch

From this switch you can choose the microphone signal

sent to CH1/CH2 or to MAIN. Switching it to "MIC1

TO CH1/MIC2 TO CH2"position, the signal will come

through CH1/CH2, after it is adjusted by the 3-band

EQ and DSP/FX control, then sent to main channel, you

can also adjust the signal by using the 7-band graphic

EQ and the DSP processor, then sent to the MAIN OUT.

Switching it to "TO MAIN" position, the signal will only

go to the main channel, after adjusted by the 7-band

graphic EQ and the DSP processor, then sent to MAIN OUT.

With two microphone

DJAP-61PB DJAP-615P

With one microphone