Consort SL Installation And User Manual - Page 2
Browse online or download pdf Installation And User Manual for Controller Consort SL. Consort SL 2 pages. Wireless controller
Print Page5. Temperature Control Mode
Temperature control for Comfort period
For this mode, switches are set as shown below.
Temperature control for Setback period
For this mode, the switches are set as shown below.
If the heating is active in the setback mode, the indicators will illuminate red and green.
Temperature control for comfort and setback periods can be used individually or together. This can also be used in
conjunction with the timer mode options.
6. External Input
The controller has an external input located on the back of the controller. The external input can be connected to
any voltage free contacts, for example, timers or BMS.
7. Installation
The controller is designed to fit onto any deep single gang box. The controller can be powered by either mains
240Vac or 12Vdc. Powering the controller with 12Vdc allows the controller to be installed in a zone 2 area, however,
the installation must comply with the Separated Extra Low Voltage (SELV) requirements.
When installing the controller the maximum size wire that can be used is 1mm
standard flex (this is to avoid damaging components).
Please note: A 12Vdc power supply does not come with this controller, however, a standard 12Vdc constant voltage LED
driver could be used.
The temperature control feature will effectively maintain the set room temperature.
The target temperature can be set using the variable resistor located at the back of
the controller as shown below. The range is 15ºC - 35ºC. Once the room temperature
reaches the set temperature, the indicators will change from green to orange. When
the room temperature drops, heating will became active and the indicators will
change to green.
Set temperature
In this mode, the controller will set heating active when the room temperature drops
below the set temperature. This feature can be used for frost protection or in situations
where a minimum room temperature must be maintained. The setback temperature
can be set using the variable resistor mounted on the back of the unit as shown
above. This can be set from 0ºC - 15ºC.
Room temperature below the set temperature.
Heating is active.
If the external input is used and the contact is closed, the indicators will
light up red and stay red. When the controller is in this function, none of
the modes will work apart from setback. If the contact is open the
controller will function as normal.
Variable resistors to
set temperature
, this can be twin and earth or
2
2