Danver 1300 CFM DOHC Series Installation Instructions & Use & Care Manual - Page 8

Browse online or download pdf Installation Instructions & Use & Care Manual for Ventilation Hood Danver 1300 CFM DOHC Series. Danver 1300 CFM DOHC Series 12 pages.

Print Page

PART 2: Electrical Connection

WARNING! Ensure that the power supply is disconnected before proceeding. Verify that the

power supply matches the ratings found on the appliance data label before proceeding. The

complete appliance must be properly grounded at all times when electrical power is applied.

Do not ground the appliance with the neutral (white) house supply wire. A separate ground

wire must be utilized. Failure to complete electrical connections properly may result in

damaged or non-functional systems. Follow instructions carefully to ensure proper

installation.

It is the owner's responsibility to ensure that a qualified person performs the electrical

connection of this appliance. The electrical installation, including minimum supply wire size,

must comply with the National Electric Code ANSI/NFPA 70-1990 (or latest revision) and

local codes and ordinances. A copy of this standard may be obtained from:

National Fire Protection Association, 1 Batterymarch Park, Quincy, Massachusetts 02169-7471

Important Electrical Requirements: Observe all National and local governing codes and

ordinances. Have all electrical installation done by a qualified electrical installer. This Hood

requires a 120 Volt, 60 Hertz electrical supply of an individual properly grounded branch

circuit protected by a 15 or 20 Amp circuit breaker. The

DANVER® DOHC Series Range Hood is supplied with a 6.0 Amp three speed fan control.

Suitable for damp location when installed in a GFCI protected branch circuit.

Wiring Instructions:

There are 3 wires on the front panel that require connection. (See Diagram Below)

120 VAC from electrical panel (usually black)

BLACK

Neutral from electrical panel (white)

WHITE

Ground from electrical panel (usually green)

GREEN

CAUTION: The neutral wire (white) must only be connected to the white neutral wire coming in

from the electrical panel.

Item #

OBL-00-008

Rev. 10-2017