3xLogic VIGIL NVR-2U-64CH Quick Start Manual - Page 3

Browse online or download pdf Quick Start Manual for Network Hardware 3xLogic VIGIL NVR-2U-64CH. 3xLogic VIGIL NVR-2U-64CH 9 pages. 64-channel network video recorder

Print Page

QUICK START GUIDE | NVR-2U-64CH

1 PRE-INSTALL AND SAFETY GUIDELINES

1.1 INTRODUCTION

Note: Read all instructions before beginning any installation.

The information in this manual outlines the recommended "Best Practices" for the installation of a server.

Although this document is a guideline, failure to follow these recommendations, especially for environmental con-

ditions, can cause unnecessary and costly problems. It is in the customer's best interest to adhere to all points in

this guide during the initial stages of system design and installation.

If the installation area does not properly support these requirements, failure of the unit is likely to occur due to

excessive heat, poor power conditions and poor cabling.

Warning: Please note the following points prior to reading this document.

1. This is sensitive computer equipment. DO NOT stack, drop, or otherwise mishandle. Failure to properly

handle this unit will result in unit damage.

2. Only use the appropriate power earth-ground cord provided with the server to the properly earth-groun-

ded, 3-prong receptacles.

3. This system should only be installed by a qualified technician using approved materials in accordance with

national, state, and local wiring codes.

4. This system should only be setup by a qualified technician with a basic understanding of the Windows oper-

ating system and intermediate networking skills.

5. This system requires proper shutdown to ensure system integrity. Failure to properly shutdown the system

can result in data loss and lengthy file rebuilding upon next boot.

6. To remove power from system, you must unplug the power cord from the equipment. Make sure the AC

power cord is unplugged before you open the chassis, add, or remove any components.

7. Removal of the top cover or any other attempted unit dis-assembly, should only be attempted by a qual-

ified technician with the express permission of Technical Support.

8. This system relies on the building's electrical service for short-circuit (over-current) protection. Ensure that

a suitable fuse or circuit breaker is present in the service.

9. It is not recommended to operate this system in a dusty environment. Failure to periodically inspect and

clean the unit may result in shutdown of the unit and eventual permanent failure requiring factory repair.

10. This equipment is not suitable for use in locations where children are likely to be present.

Warning: Failure to periodically inspect and clean the device may result in shutdown of

the unit and eventual factory repair

Caution - User-Replaceable Battery: Risk of explosion if battery is replaced by an

incorrect type. Dispose of used batteries according to the instructions.

Attention - Remplacement des piles par l'utilisateu: Danger d'explosion si la batterie

est remplacée de façon incorrecte. Remplacer uniquement avec le même type ou équi-

valent