Audiovalve LUMINARE 2015 Instruction Manual - Page 12
Browse online or download pdf Instruction Manual for Amplifier Audiovalve LUMINARE 2015. Audiovalve LUMINARE 2015 17 pages. Ultra highend headphone tube amplifier
Print PageLUMINARE
ultra highend headphone tube amplifier___________________
I n t e nd e d u s e / A p p l i c at i o n
AUDIOVALVE Hi-Fi Amplifiers are intended for use under the following circumstances only:
-
To play and transfer music of any make and fashion when this occurs in private dwellings
or studios.
-
All devices must be operated under moderate climatological circumstances, comparable to
those under which human beings usually live. When the surrounding temperature is too high,
the device will heat up beyond its optimal parameters. This can damage the amplifier.
Proper ventilation will be needed, and the amplifier should not be covered in. Allow
approximately 3 cm of air sidewise and approximately 4 cm above the amplifier to cool
the amplifier.
-
Unusually high humidity of the air increases the risk of short circuits in the device
because
of the increased conductivity. This reduces the internal insulation values dramatically
and will eventually result in a malfunction of the amplifier. This increased conductivity
also might endanger the user of the device. In general terms the amplifier should not be
used for other than its intended purpose.
Factory assembly & getting started
Once the amplifier has arrived at its desired destination, make sure the amplifier has ample time to
adjust to the climate at its new location. It is likely that the changes in temperature and humidity
between the last location and the new one, has caused condensation to build up somewhere in the
amplifier.
This can damage the device. Please allow the amplifier at least two hours to acclimatise.
The amplifier comes fully assembled, ready to go. The power-cord should not be used as yet, please
connect all other input and output connectors first (cinch-cables, speaker-cables, etc).
The device MUST be switched off during it connecting to other components, it might be damaged if
this will be done with the amplifier under power. The person operating the amplifier might be hurt as
well in this case, since power-spikes, operating currents and voltage charges may occur!
Check whether the ON/OFF switch is in the OFF position. If so, you can now plug in the
power-cord.
Use high quality cables only! Usage of DIY cables, low spec cables or cables intended
for other use voids all warranty and cancels any product liability. Make sure all plugs are connected
tightly to the amplifier. When in doubt, replace the cable.
Always use the device in a 'complete configuration' , damages may occur when devices are not
connected to the amplifier when it is being run.
Never lift the device by its glass cover, not even when there are gripps attached to the cover. The
gripps and the cover are there for ornamental purposes only. They make the amplifier look nice.
The amplifier should be positioned at a level surface, in time the construction of the glass housing
may fail as a result of tensile forces.
Please disconnect and move the amplifier when you replace tubes. Replace them at a place where
you can work easily. You might damage the 'motherboard' if you replace the tube in an awkward
position. After that please check all connectors. If all connectors are undamaged, make sure the
switch is in the OFF position, reconnect the power-cord and switch the amplifier on. You can make
sure the amplifier is properly connected by checking the tubes. Only the inside of the tube should
glow. If the steel cover jacket glows as well, the device is faulty and must be serviced immediately.
As a rule of thumb the device should work now. Don't push the volume up to its maximum just yet,
allow the device to burn in smoothly and avoid power-spikes.
The LUMINARE Pre-Amplifier needs at least a 1.6 Ampere slow blow circuit breaker in the fuse
holder for 230 VAC main voltage and 3,15 ampere slow blow by 115 VAC. Make sure your wall socket is
equipped in such a fashion.