DAPAudio CX-500 User Manual - Page 11
Browse online or download pdf User Manual for Amplifier DAPAudio CX-500. DAPAudio CX-500 12 pages. Cx series
Print Page
CX Series
Specification
Rated power /model
1kHz(HIA)with 0.5%THD
4Ω stereo(per channel)
8Ω stereo(per channel)
8Ω bridge mono
Performance
Frequency Response(at 1 Watt)
Total Harmonic Distortion(THD)
Intermodulation Distortion 60Hz
and 7KHz at 4:1 from full rated
output to -30dB
Slew Rate
Voltage Gain
Damping Factor(8Ω)10Hz-400Hz
Signal-to-Noise Ratio
(below rated power,20Hz to
20kHz. A-weighted)
Crosstalk(below rated power)
At 1kHz
At 20kHz
Input Sensitivity for full rated
power at 8Ω
Input impedance(nominal)
Balanced
Unbalanced
Construction
Protection
Ventilation
Cooling
Power cord specification
Chassis size (unit mm)
Net weight
Troubleshooting
This troubleshooting guide is meant to help solve simple problems. If a problem occurs, carry out the steps
below in sequence until a solution is found. Once the unit operates properly, do not carry out following
steps.
1.
If the device does not operate properly, unplug the device.
2.
Check the fuse, power from the wall, all cables, etc.
3.
If all of the above appears to be O.K., plug the unit in again.
4.
If you are unable to determine the cause of the problem, do not open the device, as this may
damage the unit and the warranty will become void.
5.
Return the device to your Dap Audio dealer.
CX-500/900/1500/2100/3000
CX-500
CX-900
200W
450W
150W
350W
400W
900W
27dB
31dB
Protection against short circuits, no-load , on/off muting, RF interference.
Flow-through ventilation from front to back.
Internal heat sinks with forced air . Fan cooled, speed regulated, thermal
protection.
Plug: 1OA , 250V Wire: 3x1.0mm
10,1kg
12,7kg
10
CX-1500
750W
500W
1500W
20Hz - 20KHz,+ 0-1dB
<0.5%, 20Hz - 20kHz
= / <0.35%
>10V / us
33dB
> 200
> 100dB
-75dB
-58dB
0.775V or 1.4V
20K ohms
10k ohms
2
482x256x88
13,5kg
CX-2100
CX-3000
990W
1450W
700W
1250W
2000W
2900W
34dB
37dB
482x323x88
14,5kg
19,5kg