Duratax NITRO DEMON Assembly And Operation Manual - Page 6
Browse online or download pdf Assembly And Operation Manual for Toy Duratax NITRO DEMON. Duratax NITRO DEMON 20 pages.
Print PageASSEMBLY OF THE NITRO DEMON PRE-BUILT VERSION (DTXC0075)
PREPARING THE RADIO SYSTEM
Antenna
2
Transmitter
6
5
8
8-AA Batteries
1
4-AA Batteries
1
Receiver
Battery
Holder
Throttle
Servo
Servo Arm
❏
1. Install the "AA" batteries in the transmitter and the
receiver holders.
❏
2. Extend the transmitter antenna.
❏
3. Connect the steering servo, throttle servo and switch
to the receiver. Plug the receiver battery to the switch
❏
4. Extend the receiver antenna.
❏
5. Adjust the servo trims of the transmitter to the
neutral position.
❏
6. Switch on the transmitter.
❏
7. Switch on the receiver.
❏
8. Operate the steering and throttle control. Make
sure the servo arms move in proportion to the
movement of the steering wheel and throttle trigger.
❏
9. Switch off the receiver, then the transmitter.
Before installing the radio
system in the pre-built
DuraTrax
Nitro
Demon
read the manufacturer's
instruction manual and
follow
the
instructions
shown below.
Receiver
7
Antenna
4
Switch
Receiver
3
Steering
Servo
❏
1. Remove the Nitro Demon stadium truck from
the box.
RADIO INSTALLATION
❏
2. Remove the radio tray from the chassis by
removing the (8) 3x15mm flat head self tapping
screws from the bottom of the chassis.
❏
3. Install the receiver on/off switch. Remove the two
screws from the face plate of the on/off switch and
remove the face plate. The switch should be in the
"OFF" position. Insert the on/off switch up through the
bottom of the radio plate. Then place the face plate
over the top of the on/off switch and place the two
screws back through the face plate into the on/off
switch. Be sure to reinstall the face plate with the
"OFF" position next to the switch button. Run both
wires from the on/off switch through the hole in the
side of the radio box.
6