Duratax NITRO DEMON Assembly And Operation Manual - Page 9

Browse online or download pdf Assembly And Operation Manual for Toy Duratax NITRO DEMON. Duratax NITRO DEMON 20 pages.

Print Page

❏

16. Install 4 "AA" batteries (not included) into the

receiver battery holder in the configuration molded into

the battery holder included with the radio system.

❏

17. Install the receiver battery into the radio box.

Note the placement of the receiver battery in the box.

Connect the receiver battery to the remaining end of

the on/off switch.

❏

18. Cut a 2" x 7" (50 x 175mm) piece of the included

foam and wrap it around the receiver. If desired, you can

wrap a small rubber band (not included) around the

outside of the foam to secure it in place for added security.

❏

19. Install the receiver into the receiver box as

shown. Make sure all of the wires are out from under

the receiver so that it will properly fit into the radio box.

❏

20. Cut the left over foam into small pieces and

place them around the receiver and battery to help

secure them into place. Then slide the radio box cover

back onto the radio box.

❏

21. Run the length of the antenna wire through your

fingers to help straighten the wire out, this will make it

easier to get the wire through the tube. Slide the

antenna wire through the antenna tube. Frequently,

there will be leftover wire through the antenna tube

(Do not cut or coil the antenna!) Cut two pieces of

fuel tubing 1/8" wide and slide them over the outside

of the antenna tube and wire. This is to help hold the

antenna tube on and avoid getting the antenna wire

cut in a roll over. Note the placement of the tubing on

the antenna tube.