DAPAudio PA-306 Manual - Page 9

Browse online or download pdf Manual for Amplifier DAPAudio PA-306. DAPAudio PA-306 15 pages.

Print Page

21. 8 Ω terminal

Connect this terminal to the + terminal of your 8 Ω speaker(s). In case of using several speakers.

Make sure that the total speaker load is 8 Ω. The total power rating of the low impedance speakers

connected to this terminal summed, should be at least 30W.

22. 100V terminal

Connect this terminal to the + terminal of your 100V speaker(s). In case of using several speakers make

sure all speakers are wired in parallel.

The total power rating of the 100V-speakers connected to this terminal summed, should never exceed

30W.

23.

AC Inlet with integrated fuse holder

This connector is meant for the connection of the supplied main cord. Connect one end of the power

cord to the connector, the other end to the mains, then turn on the power (14) switch to operate the

unit.

Make sure that the supply voltage matches the operation voltage before connecting the unit to mains.

Replace the fuse only with a fuse of the same specification (230V:T800mA, 115V:T1,6A).

24.

GND Screw

This screw offers a separate ground connection. Can be useful in case of grounding problems.

25. 4 Ω terminal

Connect this terminal to the + terminal of your 4 Ω speaker(s). In case of using several speakers.

Make sure that the total speaker load is 4 Ω. The total power rating of the low impedance speakers

connected to this terminal summed, should be at least 30W.

26. 70V terminal

Connect this terminal to the + terminal of your 70V speaker(s). In case of using several speakers make

sure all speakers are wired in parallel.

The total power rating of the 70V-speakers connected to this terminal summed, should never exceed

30W.

27. Line out

RCA stereo line lvel output for connecting a recording device or an additional amplifier.

28. Line 3 input

RCA stereo input for connecting a line level device such as an I-pod, CD player etc.

29. Line 2 input

RCA stereo input for connecting a line level device such as an I-pod, CD player etc.

30. Mic 3 input

Mic level XLR input for channel 3. Accepts balanced and unbalanced inputs.

31. Mic 2 input

Mic level XLR input for channel 2. Accepts balanced and unbalanced inputs.