Duratool D01843 Instructions - Page 4
Browse online or download pdf Instructions for Soldering Gun Duratool D01843. Duratool D01843 4 pages.
CLEANING
•
Cleaning should only be done when the iron is switched off and at room
temperature.
•
The iron may be cleaned with a damp cloth and a small amount of liquid detergent
if necessary.
•
Never submerse the soldering iron in liquid or allow any liquid to enter the case.
•
Do not use any chemicals, abrasives or solvents that could damage the soldering
iron.
TROUBLESHOOTING
•
Tip heats intermittently -
•
Tip will not reach set temperature - Defective heating element
•
Solder will not wet the tip -
•
Increased resistance between
tip and ground -
SPECIFICATIONS
Power Consumption
Input Voltage
Temperature Range
Box Dimensions (L x W x H)
Weight
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF ELECTRICAL &
ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste
Electrical & Electronics Equipment (WEEE). Any WEEE marked products must
not be mixed with general household waste, but kept separate for the treatment,
recovery and recycling of the materials used. Contact your local authority for details
of recycling schemes in your area.
Mains cord damaged or a loose connection.
Tip temperature is too high.
Tip is badly oxidized and requires cleaning.
Check the tip attachment is tightened.
48W
220-240V~50Hz
150-450°C
115 x 85 x 140mm
0.6kg
4
Made in China. PR2 9PP
Man Rev 1.0