Duratool D03292 Quick Start Manual - Page 2
Browse online or download pdf Quick Start Manual for Soldering Gun Duratool D03292. Duratool D03292 4 pages.
Print PageIMPORTANT SAFETY INFORMATION
Please read these instructions carefully before use and retain for future reference
•
When using electrical appliances basic safety precautions should always be
followed.
•
Check that the voltage indicated on the rating plate corresponds with that of the
local network before connecting the appliance to the mains power supply.
•
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
•
Children shall not play with the appliance. Cleaning and user maintenance shall
not be made by children unless they are older than 8 and supervised.
•
Do not operate the appliance with a damaged plug or cord, after a malfunction or
after being dropped or damaged in any way.
•
If the supply cord is damaged, it must be replaced by a qualified engineer in order
to avoid injury or a hazard.
•
Ensure there is sufficient space and ventilation around the appliance to allow the
escape of heat and/or fumes.
•
Do not expose to rain or moisture.
•
Never place the product or part of it in water, or operate if your hands are wet.
•
Soldering work must be conducted on a stable, non-combustible surface.
•
Do not touch any metallic parts near the soldering tip/nozzle.
•
The iron must not be left unattended while it is connected to the supply mains.
•
Turn the soldering iron off and unplug it when it is not in use.
•
This device must be earthed through the mains lead and plug.
WHAT'S INCLUDED
•
Soldering Station and Iron
•
De-solder pump
•
Helping hand magnifier
•
Scraper and brush tools
•
2 spare tips
•
Lead free solder wire
•
User manual
APPLICATION & OPERATION
Note: The first time you use the soldering iron, it may smoke slightly as the heating
element dries out. This is normal and should only last for a few minutes.
ONLY USE FOR ELECTRICAL WORK - Acidic solder will damage the iron tip.
•
Connect the mains plug and turn on the power using the switch on the station. The
switch will illuminate when the power is on.
•
Regulate the temperature of the iron using the rotary control.
•
The coloured areas correspond to the following temperatures:
Yellow - approx 150
Orange - approx 150 to 270
Red - approx 270 to 480
•
It is recommended to use the lower part of the first red sector for lead solder and
for silver solder use the lower end of the second red sector.
o
C
o
C
o
C
2