Duratool D03200 Manual - Page 4

Browse online or download pdf Manual for Power Tool Duratool D03200. Duratool D03200 4 pages.

Print Page
Note
•
If you are uncertain which setting to use, start with a lower setting and increase if
required.
•
To switch the tool off and decrease the cooling down time, set the on/off switch to
position I and let it run for a few minutes. Then set the on/off switch to position 0.
Let the tool cool down before moving or storing it.
ACCESSORY FITTING
•
Removing or fitting accessory tools should only be done when the heat gun is
switched off and cooled down.
•
The tools are a firm slip on fit onto the nozzle.
CLEANING
•
Cleaning should only be done when the heat gun is switched off and at room
temperature.
•
Keep the ventilation slots clear of debris.
•
The heat gun may be cleaned with a damp cloth and a small amount of liquid
detergent if necessary.
•
Do not use any chemicals, abrasives or solvents that could damage the casing.
SPECIFICATION
Voltage
Power
Air temperature/flow
Setting I
Setting II
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF
ELECTRICAL & ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste Electrical
& Electronic Equipment (WEEE). Any WEEE marked products must not be mixed with
general household waste, but kept separate for the treatment, recovery and recycling of
the materials used. Contact your local authority for details of recycling schemes in your
area.
220-240V~50Hz
2000W
50
o
C / 250-500l/min
o
o
50
C-650
C / 250-500l/min
Made in China. PR2 9PP
Man Rev 1.1