DAPAudio DS-CM-12MP3 Product Manual - Page 15

Browse online or download pdf Product Manual for DJ Equipment DAPAudio DS-CM-12MP3. DAPAudio DS-CM-12MP3 20 pages.

2) Pitch-Bending
• The BPM increases or decreases respectively while the PITCH BEND + or PITCH BEND - button is
pressed.
• The BPM increase depends on how long you hold the button. If you hold the button for about 5
seconds, the BPM will go either to +8/ +16/ +24% for PITCH BEND + or -8/ -16/ -24% for PITCH BEND -.
If you tap the button, the BPM will only change a little so you can change the beat slightly without
audible changing in the music.
• The track will return to the BPM set by the Pitch slider when you release the PITCH BEND + or
PITCH BEND - buttons.
11. Loop PLAY
1. Press the Loop IN button to set the loop start point, the Loop indicator will flash on the LCD.
2. Press the Loop OUT button to set the loop end point. After the end point is set, the playback will
enter the loop play from start point to end point repeatedly.
3. Press one of the Loop buttons again, the loop play function is canceled, the Loop indicator
dimms.
12. Reloop
1. If you press the Reloop button, the SD-card PLayer starts at the last selected loop.
2. Press the button over and over rapidly to start the loop again and again.
3. Press one of the Loop buttons again, the loop play function is canceled, the Loop indicator
dimms.
13. Repeat
1. Press the Repeat button once to repeat the current track The display shows "REPEAT 1".
2. Press the Repeat button again to repeat the current folder. The display shows "REPEAT FOLDER".
3. Press the Repeat button again to repeat the whole SD card. The display shows "REPEAT ALL"
4. Press the Repeat button a fourth time, to exit the Repeat Mode.

Set Up and Operation

Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connection Cables
Take care of your cables, always holding them by the connectors and avoiding knots and twists when
coiling them: This gives the advantage of increasing their life and reliability.
Periodically check your cables. A great number of problems (faulty contacts, ground hum, discharges,
etc.) are caused entirely by using unsuitable or faulty cables.
Headphones
Unbalanced mono
Balanced mono
13
Insert