Duratuf KIWI SHEDS KS1 Assembly Instructions Manual - Page 12

Browse online or download pdf Assembly Instructions Manual for Storage Duratuf KIWI SHEDS KS1. Duratuf KIWI SHEDS KS1 18 pages.

Print Page

Note:

Condensation can form on the under side of shed roof. If building paper is required, fit now. Building paper will need to be

supported by netting or roofing twine.

Roof with Clear Panel: Handle Clear Panel with care. The Clear Panel will crack if not fitted correctly.

Riveting: Pre-drill 3.5mm hole through Clear Panel and Steel. Enlarge hole in Clear Panel with drill to allow for expansion

and contraction.

Screwing: Pre-drill a 6mm hole through the Clear panel.

Step 1: Check that the diagonal measurements of the shed are the same. If building on unlevel ground it may be necessary to

temporarily brace the shed with pieces of timber from the packaging.

Step 2: Position Roof Sheets. Ensure they fit flush

with the ribs on the back wall—should over-

hang by 20mm. Ensure timber plates are

straight then screw roof to Top plates using

one 50mm Roofing Screw on each Rib at the

front. Repeat along the back wall using

50mm clouts, instead of Roofing Screws to

allow Ridge Cap Flashing to sit correctly on

roof sheets.

Step 3: Position Roof Sheets. They should overhang

the back top plate by 20mm. Ensure timber

plates are straight then screw roof to Top plates

using one 50mm Roofing Screw on each Rib at

the front. Repeat along the back wall using

50mm clouts, instead of Roofing Screws to

allow Ridge Cap Flashing to sit correctly on

roof sheets.

KS1 ROOF