DURAVAC VJH1211PF 0501 Operator's Manual - Page 7

Browse online or download pdf Operator's Manual for Vacuum Cleaner DURAVAC VJH1211PF 0501. DURAVAC VJH1211PF 0501 16 pages.

Print Page

GENERAL ASSEMBLY INSTRUCTIONS

A Philips head screw driver is required.
1
2
6c
6b
11
10
WARNING
: DO NOT PLUG POWER CORD INTO POWER OUTLET. MAKE SURE
PLUG IS DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VACUUM. TO REDUCE
THE RISK OF ELECTRIC SHOCK, DO NOT EXPOSE TO RAIN.
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Undo the latches (Fig. 2).
3. Lift the power head off the collection tank (Fig. 3).
4. Remove the contents from inside the collection tank. Make sure you have all contents as listed
on page 6 (Fig. 4).
5. Turn the collection tank upside down and insert the four caster feet into the slots on the
collection tank and tighten with supplied screws. Verify that the casters are mounted correctly.
Do not over-tighten screws (Fig. 5).
6. Position the hose storage rack as illustrated. Fully insert one end of the hose storage rack into
the slot illustrated by the arrow, then pull the other end of the hose storage rack to align with
the corresponding arrow and insert into the slot until it is secured in place (Fig. 6a - 6d).
7. Your vacuum comes ready for dry vacuum cleaning. If the cartridge filter is not installed, refer
to page 13 for installation instructions (Fig. 7 & 8).
8. For wet vacuum cleaning, remove the cartridge filter, and install the supplied foam wet filter
See page 14 for the foam wet filter installation instructions (Fig. 9).
9. Place the power head back on the collection tank, and secure into place using the 2 side
latches (Fig. 10 & 11).
10. Insert the locking end of the hose into the vacuum port of the collection tank and turn clockwise
to lock into place (Fig. 12).
11. Choose the desired accessory and insert onto the end of the hose or extension wand (Fig.
13).
NOISE DIFFUSER
For quiet operation, install the noise diffuser into the blower port by inserting the locking end of the
diffuser into the blower port and turning clockwise to lock into place.
3
4
7
6d
13
12
7
5
6a
8
9