DuraVent PolyPro Series Installation Instructions Manual - Page 10

Browse online or download pdf Installation Instructions Manual for Fan DuraVent PolyPro Series. DuraVent PolyPro Series 20 pages. Polypro single-wall and concentric gas vent system for category ii & iv gas-burning appliances

Print Page
POSITIONED
HORIZONTALLY
INTERIOR
WALL PLATE
Horizontal Twin Pipe (Fig.11)
1.
Locate penetration.
Cut and frame hole. (Table 3)
2.
3.
Attach Interior Wall Plate to interior wall.
4.
Attach and seal Exterior Wall Plate to
exterior wall.
5.
Slide pipes through outer plate.
6.
Rotate pipes to slide pipe past keyway.
7.
Slide Exhaust Tip into exhaust pipe.
8.
Mount Outer Cover Plate to exterior wall
plate.
9.
Install Poly Pro venting system from
appliance to termination.
Lochinvar / IPEX twin plate termination
connector- 2" installation (Fig.12)
1.
Slide PolyPro pipe w/ PVC adapter into
oblong hole and down. Brackets will
point away from the wall on the exterior
of the house and rest between the two
outward beads.
2.
Install the termination assembly
in accordance with appliance
manufacturer's instructions.
3.
Verify exhaust pipe cannot be removed
from termination cap.
Lochinvar / IPEX twin plate termination
connector- 3" & 4" installation (Fig.13)
1.
Slide PolyPro Pipe w/ PVC adapter into
small hole of retaining plate until it stops
on the adapter collar.
10
EXTERIOR WALL PLATE
EXHAUST PIPE
APPLY BEAD OF SILICON SEALANT
AROUND FEMALE END OF PIPE TO
SEAL AGAINST EXTERIOR WALL PLATE
EXHAUST TIP
OUTER COVER PLATE
AIR INLET PIPE
Figure 11
POLYPRO PIPE
W/PVC ADAPTER
(SUPPLIED WITH
TERMINATION KIT)
POLYPRO PIPE
W/PVC ADAPTER
(SUPPLIED WITH
TERMINATION KIT)
2.
Finish installing the termination
assembly in accordance with appliance
manufacturer's instructions. PolyPro pipe
is to be installed on the exhaust outlet.
3.
Once securely installed to exterior, verify
exhaust pipe cannot be removed from
termination cap.
POSITIONED
VERTICALLY
BRACKET
Figure 12
Figure 13