APlusLift HW-10KOH Installation Manual & Operation Instructions - Page 13

Browse online or download pdf Installation Manual & Operation Instructions for Lifting Systems APlusLift HW-10KOH. APlusLift HW-10KOH 17 pages. 2-post over head car lift 10,000lb capacity
Also for APlusLift HW-10KOH: Installation & Operation Manual (20 pages)

APlusLift HW-10KOH Installation Manual & Operation Instructions
Push Up switch to raise lift (make sure arm restraints engage or stop and slightly move arm to allow gear to mesh)
until tires clear floor.
Stop and check for secure contact on adapters and vehicle weight distribution. If secure raise to desired height.
ALWAYS lower the lift into the nearest lock position by pressing the lower lever to relieve the hydraulic pressure
and let the latch set right in a lock position.
Never work under a lift that is not in the locked position.

Lowering Lift

Clear all obstacles from under lift and vehicle and ensure only the lift operator is in the lift area.
Stay clear of lift and raise the lift off the safety locks by 2".
Pull safety latch releases cable ring one by one on each carriage and press the lower lever to begin descent.
Unload lift by first completely lowering lift, then swinging arms to drive through position before moving vehicle.
3.
Maintenance & Safety
MAINTENANCE
Note: IT IS THE CUSTOMER'S OR THE END USER'S RESPONSIBILITY TO MAINTAIN THE PROPER
TENSION ON THE EQUALIZER CABLES. ASKF A QUALIFIED TECHANICAN TO RETURN IN FUTURE
TO MAINTAIN THE CABLE ADJUSTMENT AFTER THE LIFT IS INSTALLED WOULD NOT BE A
WARRANTY FOR THE ADJUSTMENTS.
IF AT ANY TIME YOU'RE NOT SURE TO THE SAFE OPERATION OF THE LIFT, DISCOUNTINUE USING
IT AND CALL YOUR DISTRIBUTOR FOR ASSISTANCE.

Lubrication:

Lubricate all Nylon wear block corners inside each column with heavy duty bearing grease before your first operation
and once every six months. Lubricate chains every six months.
Anchor Bolts:
During first week of use, check anchor daily. DO NOT use an impact wrench. After first week, check once a month
for the first six months. Tighten if necessary.
Concrete:
Check concrete for stress cracks daily for the first two weeks of use as a precaution. Thereafter, check monthly.
Check all bolts and nuts every six months.

Hydraulic Oil:

If your lift will raise all the way to the top of the hydraulic tank is full of hydraulic oil. The hydraulic oil should be
changed once a year, along with cleaning the suction filer.
SAFETY LATCH ADJUSTMENT
DO NOT make any adjustment on the lift or cable.
13