DURAVIT Inipi Operating Instructions Manual - Page 10
Browse online or download pdf Operating Instructions Manual for Plumbing Product DURAVIT Inipi. DURAVIT Inipi 19 pages.
Also for DURAVIT Inipi: Pre-Installation (10 pages)
Print Page
Set units is displayed.
> Select the required units.
You've now finished configuring the control panel.
Step 2: Fill the vaporiser water tank
> Unscrew the vaporiser water tank from behind the flap in the furniture.
> Fill the water tank with distilled water.
> When required, add fragrant essential oils to the water, according to the manufac-
turer's instructions.
> Screw the water tank back in.
> Empty the vaporiser water tank again after the sauna bath to prevent microbial
contamination of the water.
7. Operating the Sauna
7.1
Switching on the sauna
> Turn the light switch to ON.
The emergency light is switched on.
> Turn the mains switch to ON.
The emergency light may flicker while the controls is starting.
> Press the "On/Off" button.
The operating unit is switched on, the emergency light is switched off.
If you've activated a PIN-request, enter the PIN as follows:
> Press the "up" or "down" button until the first digit of the PIN is displayed.
> Press the "right" button to select the next digit.
> Repeat those last two steps until you have entered the PIN.
> Press the "OK" button.
You can now switch on the separate parts of the sauna via a scenario or via functions
(heater, lighting, music).
7.2
Switching off the sauna
Note!
Damage to the cabin due to overflowing water.
18
> Empty the collection tray after every sauna bath and before you refill the vaporiser
water tank.
> Press the "On/Off" button.
> Select switch off.
The sauna is switched off.
> Turn the light switch to OFF.
The emergency light is switched off.
> Turn the mains switch to OFF.
Power supply to the sauna is switched off.
7.3
Switching on a scenario
> Select scenarios.
> Select the scenario you wish to use.
The heater starts to heat up, other settings are not yet started.
Once the air temperature* is reached, the following is seen on the control panel:
"Air temperature reached! Start scenario?".
> Press the "OK" button to confirm.
Perform other scenario settings.
If you would like to enjoy music or coloured lighting while the sauna is heating up, you
can switch these on individually. Follow the instructions given under the individual
functions.
*It may still take some time before the sauna is ready, refer to the chapter entitled
"Product Information" to learn more about the "warm-up period".
7.4
Switching off a scenario
> Select scenarios > switch off.
The scenario is switched off.
7.5
Changing a scenario*
... permanently
> Select scenarios > change.
19