APOCALYPSE APOC01 User Manual - Page 3

Browse online or download pdf User Manual for DJ Equipment APOCALYPSE APOC01. APOCALYPSE APOC01 5 pages.

Print Page

4. Main Function

1、 Mains input: IEC socket and integrated fuse holder, connect to main power cable.

2、 Cooling fan: Cool down the working temperature.

3、 DMX OUT: Transmit DMX signals by XLR female socket.

4、 DMX IN: Receive DMX signals by XLR male socket.

5、 Only for remote controller: By connect to the 1/4'' microphone jack to control the unit

for Stand by, Function and Mode function.

6、 Hanging bracket: with 2 knobs on both sides to fasten the unit and a mounting hole to

fix a mounting hook.

7、 Sensitivity: To adjust the sound receiving sensitivity.

8、 Microphone: To receives audio signal for sound activation.

5.Lamp Replacement

Lamp type: MSD 250W

•

Always switch off the main supply and never handle the

lamp when is hot.

•

Do not touch the lamp with bare hands. If this happens,

clean the lamp with denatured alcohol and wipe it with a

lint free cloth before installation.

•

The lamp generates UV radiation. Never operate the lamp

without appropriate shielding.

• The risk increases with age, temperature and improper

handling of the lamp. Do not use the lamp any longer than its

specified life.

6. How To Control The Unit

Three ways to operation:

A. Master/Slave operation

B. Easy controller CA-8

C. Universal DMX controller

6.1 Master/Slave operation

The unit can be linked together in daisy chain as many as you need in master/slave mode to

perform the great built-in pre-programmed lighting shows triggered by music.

In Master/Slave mode refer to the DMX settings below:

Master unit: DMX start address MUST be set to 001. ( first DIP switch = ON, all other

are OFF)

Slave units: DMX start address may have any value but NOT 001 ( example: set the

first 3 DIP switches to ON)

﹡

2-light show

Dipswitch 10 "off" means the unit works normally and "on" means inversion. In order to

create a great light show, you can set dip switch 10 "on" on any unit that is linking to the

master unit to get contrast movement to the master unit, even if you have two units only.

Dipswitch 10 on the first ( Master ) unit is no use for the 2-light show as it is the master unit

that operates the light show.

6.2 Easy Controller (by CA-8)

The easy remote control is used only in master/slave mode. By

connecting to the 1/4" microphone jack of the first unit (its DMX input

plug is not used), you will find that the remote control all the first unit

will control all the other units for Stand by, Function and Mode.

Built-in lighting shows triggered by Easy Controller:

Stand by

Blackout the unit

1. Clockwise (Fast speed) (Middle speed) (Slow speed)

Function

Shutter in sync

2. Counterclockwise (Slow speed) (Middle speed) (Fast speed)

Mode

Sound (LED OFF)

Slow (LED ON)