Apogee QUICK DRAW Manual - Page 3

Browse online or download pdf Manual for Toy Apogee QUICK DRAW. Apogee QUICK DRAW 12 pages.

Apogee QUICK DRAW Manual
… 8. Remove the parts of the fixed mount installation jig from
the cardstock sheet (P/N 12705) with a sharp hobby knife.
… 9. Assemble the three frame pieces by inserting the tabs
into the slots. Do not glue yet.
… 10. Install both cardstock rings on the end of the assem-
bled frame that has tabs. Apply wood glue to the joints
and let the installation jig dry completely.
… 11. Once both the fixed mount and the installation jig are
completely dry, ensure that there are no glue blobs or pro-
trusions that may impair the motion of removable mounts.
Dried blobs can generally be removed by snapping them
off with the tip of a hobby knife. To prepare the fixed
mount for installation, latch the jig into it by aligning the
tabs, inserting, and rotating clockwise into place.
… 12. Do a trial fit of the fixed mount in the aft end of the
marked tube. If there are any glue blobs or misalignments
that make insertion difficult, sand the outer surface of the
mount until it can be slid into the tube smoothly.
… 13. Remove the mount and jig, then use a dowel to apply a
bead of wood glue approximately 1/8" (3mm) wide to the
interior of the tube beginning 3-1/4" (83mm) from the aft
end.
… 14. Slide the fixed mount and jig into the tube and rotate
the mount into the glue (to distribute it over as much sur-
face as possible) pushing all the way until the jig stops at
the edge of the tube. This will place the fixed mount at the
correct depth and ensure correct alignment.
… 15. Check from the front side of the tube (the open end)
that no glue has overflowed onto the installation jig. Clean
any drips with a dowel. Allow the mount to dry for several
minutes before removing the installation jig. To remove
the jig, rotate it counterclockwise until the tabs on the jig
line up with the openings on the fixed mount and pull the
jig out. The fixed mount is now installed. Allow it to dry
completely before removable mounts are inserted.
Step 8
Step 9
Step 10
Step 11
DO NOT GLUE
Step 12
DO NOT GLUE
Step 13
3-1/4"
83mm
Step 14
Step 15
Inserts smoothly
all the way
Glue spreads as
mount is inserted
Page 3