DURAVIT Zencha Quick Start Manual - Page 3

Browse online or download pdf Quick Start Manual for Bathtubs DURAVIT Zencha. DURAVIT Zencha 7 pages. Bathtubs and whirltubs

Print Page

Pre-installation

INSTALLATION LOCATION / INSTALLATION ROOM

> Make sure that the installation location fulfils the following criteria

Doors / external

• Ensure that doors or other access openings are

access

large enough to accommodate transport dimen-

sions, keeping in mind the weight and need for

sufficient manoeuvring room.

Required area

• Allow for enough space around the tub for the in-

stallation.

Floor

• Completely level.

• At a right angle to the wall.

• Note the overall strength of the floor structure

including the floor finish.

• There must not be any underfloor heating under

the tub.

• Install tubs after the tiles. (Top edge of finished

floor).

• Depending on the combination of tub and whirl

system it is possible that system components may

protrude beyond the edge of the tub. We there-

fore recommend installation in a support frame.

• Tolerances for acrylic: As a result of the manu-

facturing process, deviations from the nominal

dimensions may occur within the limits specified

in the DIN 198 standard. Please take this into

account in your planning.

Wall

• Tiled.

• At a right angle to the tub.

• Completely straight.

• Note the overall strength of the wall structure

including the wall finish.

WATER INSTALLATION

Water connection

• Connections for the water supply and drains must be in compliance

with the currently valid standards and public regulations.

• Position the water drain (DN 50) flush to the mounting surface or out of

the wall directly above the mounting surface; see drawing for recom-

mended area.

MAINTENANCE OPENINGS AND AIR SUPPLY

• The air supply for the whirl system (ventilation grille/ventilation slot)

must not be covered.

ELECTRICAL INSTALLATION

DANGER

Risk of fatal electric shock

> Disconnect the power supply while working on the electrical

components.

> The device must be earthed. Earthed appliances must be permanently

connected to fixed wiring.

> Connect the device only to the designated electrical cable.

> NEVER touch the power supply line with wet hands.

Pre-installation

> Lay a permanent power supply line which must be on a separate

circuit.

• The device itself does not have electrical leakage protection func-

tion. The device must be supplied through a residual current device

(RCD) with a rated residual operating current not exceeding 30 mA.

• Means for disconnection must be incorporated in the fixed wiring

in accordance with the wiring rules and have a contact separation

in all poles that provides full disconnection under overvoltage cat-

egory III conditions outside the prescribed protection zones (0 – 2).

• Leave 3000 mm of the supply line exposed.

> Lay an equipotential bonding cable:

• Leave 3000 mm of cable exposed.

> Select a supply line cross-section based on the connected load on the

identification plate (2.5 mm – 4 mm).

> Confirm that the grounding wire is 10 mm (⅜ ") longer than the L and

N wire.

> Install a circuit breaker.

Protection zones

6 0

* Or the height of the highest fixed-location shower head/water outlet,

whichever is higher.

Electrical data

Whirl system

Air System (DuraSolid)

(# 760XXX XX X AS 00XX)

Power supply

# 76XXXX XX X XX XXX0:

# 76XXXX XX X XX XXX6:

Fuse

RCD

Rated power with

Max. rated power,

standard equipment

fully-equipped

0.58 kW

220 – 240 V AC, 50 Hz

220 – 240 V AC, 60 Hz

= 16 A

≤ 30 mA

ΔN

Pre-installation data sheet Zencha_22.07.1